Rockwell Automation 6189x Integrated Display Industrial Computers User Manual - Manual (Page 114)

114 Rockwell Automation Publication 6181P-UM003A-EN-P - May 2014
Appendix B Accessories Installation
Install an Add-in Card Display and non-display computers support half-length, full-height add-in cards.
Half-length PCI/PCIe cards are 106.68 mm (4.2 in.) high by 175.26 mm
(7.0 in.) long.
The following table lists PCI/PCIe slots and configurations supported by the
display and non-display computers.
Any PCI/PCIe configuration supports 12 W (maximum) internal to the PCI/
PCIe slot and 28 W (maximum) external to the computer, for a maximum load of
40 W. Verify that your card does not exceed its thermal ratings.
When the computer is running at its maximum rated temperature, the ambient
temperature in the PCI/PCIe slot operating with a 4 W fanless card can reach
70 °C (158 °F). With a 12 W load, the ambient temperature can reach 90 °C
(194 °F). Your PCI/PCIe slot temperatures can be lower based on the power
usage of your specific application.
Follows these steps to install an add-in card (the performance computer is shown).
1. Follow the steps for
Pre-configuration on page 44 .
2. Remove the computer cover as detailed in
Remove the Cover on page 45 .
Computer Model
Default
One-slot
Configuration Alternate One-slot
Using PCI Riser Kit
(Cat. No. 6189V-PCIR) Alternate Two-slot
Using PCI/PCIe Extender Kit
(Cat. No. 6189V-EXTPCI2)
All display and non-display 1 PCI Express x8 1 PCI • 2 PCI
• 2 PCIe x4
• 1 PCIe x4 + 1 PCI
ATTENTION: Add-in cards are sensitive to ESD and require careful handling:
• Hold cards only by the edges.
• Do not touch the card connectors, components, or circuits.
• After removing an add-in card, place it on a flat, static-free surface, component
side up.
• Do not slide the card over any surface.
IMPORTANT Use an antistatic wrist strap connected to the work surface, and properly
grounded tools and equipment.