Rockwell Automation 6189x Integrated Display Industrial Computers User Manual - Manual (Page 30)

30 Rockwell Automation Publication 6181P-UM003A-EN-P - May 2014
Chapter 2 Installation
Mount the Display Computer in a Panel
Mounting clips secure the display computer to the panel. The number of clips
varies by model.
Follow these steps to mount the computer in a panel.
1. Remove power from the panel.
2. Verify that the panel surface around the area to be cut is clean and free of
be debris.
3. Cut an opening in the panel by using the appropriate panel cutout
dimensions.
4. Attach cables to the computer before installation if rear access to the
computer is limited after installation.
For where to attach cables, see Connect Peripherals on page 33 .
AC power models: If necessary, remove the AC retention clip before
installing the computers in a panel cutout. Reattach the clip after installing
the computer.
5. Make sure the sealing gasket is properly positioned on the computer.
This gasket forms a compression-type seal. Do not use sealing compounds.
6. Place the computer in the panel cutout.
7. Slide the mounting clips into the holes on the top, bottom, and sides of the
computer.
Model Bezel Clips (qty.) Cat. No. Description
1200P Standard Aluminum 10 6189V-MCLPS3 Replacement mounting clips (14)
1500P Standard
1500P Widescreen 12
1700P Standard 10
1900P Standard 14
1900P Widescreen
1500P Stainless steel 10
1700P 12
1900P 14
ATTENTION: Take precautions so metal cuttings do not enter
components already installed in panel to avoid personal injury or
damage to the panel components.