Rockwell Automation 6189x Integrated Display Industrial Computers User Manual - Manual (Page 52)

52 Rockwell Automation Publication 6181P-UM003A-EN-P - May 2014
Chapter 4 Component Replacement
Replace the Power Supply
Unit Follow these steps to replace the power supply unit (PSU).
1. Follow the steps for
Pre-configuration on page 44 .
2. Place the computer on a flat, steady surface with the rear cover facing
upward.
3. Remove the eight screws that secure the computer to the display panel (A).
4. Lift and slide the computer forward so you can unplug the display cables (B).
IMPORTANT Use an antistatic wrist strap that is connected to the work surface and properly
grounded tools and equipment when handling internal computer components.
DC Powered Integrated Display Model Shown
B
A
A
A
A
A
A
A
A