Rockwell Automation 6189x Integrated Display Industrial Computers User Manual - Manual (Page 94)

94 Rockwell Automation Publication 6181P-UM003A-EN-P - May 2014
Chapter 6 System Troubleshooting
Load the System Defaults If the computer fails after you make changes in the set-up menus, load the system
default settings to correct the error. These default settings have been selected to
optimize your computer’s performance.
Follow these steps to load the system defaults.
1. Restart the computer as specified in
Restart the Computer on page 41 .
2. During POST, press F2 to access the UEFI set-up utility.
3. Click Firmware Configuration on the set-up screen.
4. Click Default (A) on the Main screen.
5. Click Save (B) to save your changes.
6. Click Exit (C) to exit the UEFI set-up utility.
IMPORTANT For display computers with aluminum bezels, you can access the
diagnostic utility during POST by pressing the UIB on the front of the
display; see
page 17 for more information about the UIB.
A B C