Rockwell Automation 2093-xxxx Kinetix 2000 Multi-axis Servo Drive User Manual - Manual (Page 149)

149 Publication 2093-UM001A-EN-P — March 2007
Chapter
8
Removing and Replacing the Kinetix 2000
Drive Modules
Introduction This chapter provides remove and replace procedures for your Kinetix 2000
system components.
Before You Begin You will need the following tools available before you begin removal and
replacement procedures:
• A flat-blade screwdriver
• A small flat-blade screwdriver, 3.5 mm (0.14 in.)
• Voltmeter
Topic Page
Before You Begin 149
Remove Modules from the Power Rail 150
Replace Modules on the Power Rail 151
Remove the Power Rail 151
Replace the Power Rail 152
ATTENTION
This drive contains ESD (Electrostatic Discharge) sensitive parts and
assemblies. You are required to follow static control precautions when
you install, test, service, or repair this assembly. If you do not follow
ESD control procedures, components can be damaged.
If you are not familiar with static control procedures, refer to
Allen-Bradley publication 8000-4.5.2, Guarding Against Electrostatic
Damage, or any other applicable ESD Protection Handbook.