Brother HL-5050 - Manual (Page 114)

TROUBLESHOOTING 6 - 3
Error message printouts
The printer will report problems by printing an error message as defined in the following table. Take the
corrective actions for the error message.
Error message Action
MEMORY FULL ■ Press the Go button to print the data left in the printer. Press the Job Cancel
button if you want to delete the data left in the printer.
■ Reduce the print resolution or reduce the complexity of your document.
■ Expand the printer memory by adding a commercially available DIMM. See
Installing additional memory in Chapter 4.
PRINT OVERRUN ■ Press the Go button to print the data left in the printer. Press the Job Cancel
button if you want to delete the data left in the printer.
■ If this does not clear the error, reduce the complexity of your document or
reduce the print resolution.
■ Expand the printer memory by adding a commercially available DIMM. See
Installing additional memory in Chapter 4.
■ Set page protection to ON by using the supplied Windows driver or RPC
program.
■ Change the following settings in the supplied Windows driver and try again.
The best combination of these settings will vary depending on your document:
Graphics Mode
TrueType™ mode
Use Printer TrueType™ Fonts
RESOLUTION REDUCED
TO ENABLE PRINTING
(The printer has printed the
document at a reduced
resolution) ■ Reduce the complexity of your document before you print to prevent
automatic reduction in the resolution.
■ Expand the printer memory by adding a commercially available DIMM. See
Installing additional memory in Chapter 4.