Networking ki pro using the factory default ip, Test ki pro’s network connection with “ping, Mac ping procedure – AJA Ki Pro User Manual

Page 38: Controlling ki pro from a web-browser, Controlling ki pro via 802.11b/g

Advertising
background image

Ki Pro v3.2

www.aja.com

38

Networking Ki Pro
using the Factory
Default IP

If you don’t want to use DHCP to network Ki Pro and also don’t want to set your own
static IP address, you can simply use a Default setting to use a factory setting of
10.65.74.65. This might be useful for an application where you directly connect a laptop
or computer to Ki Pro and want to get networking quickly. Here are the steps to set up
this method of communication:

1. Use the Select buttons to navigate to parameter “50.1 IP CONFIG”, and then use the

Adjust buttons to select “Default”.

2. Set your laptop or desktop computer Ethernet IP address to 10.m.n.m (where m is not

65 and n is not 74).

3. Also on the computer, set the Subnet mask to 255.0.0.0 (most PCs default to the

proper netmask when the address is set—so you may not have to do anything here).

4. Run a browser on the computer and type “10.65.74.65” (the Default factory IP

address). You should now see Ki Pro’s browser status screen.

Test Ki Pro’s
Network
Connection with
“Ping”

After setting the IP address and other TCP/IP settings and connecting Ki Pro’s Ethernet
connection to a LAN or directly to a computer, ensure that you have a valid connection
by “Pinging” the Ki Pro. Pinging ensures that other devices on the network, or a computer
directly attached to it, can see it. Simply run the Ping utility from a computer on the same
LAN as Ki Pro, or one attached directly to Ki Pro. Here’s how to Ping a Ki Pro from a Mac
OSX computer:

Mac Ping Procedure

1. Find the Applications Folder, and then find the Utilities Folder inside of the

Applications Folder.

2. Locate the “Terminal” utility application and double-click it.

3. On the Ki Pro, go to parameter menu 50.2 and read the IP address.

4. At the Terminal prompt, enter the IP address noted in step 3. For example: ping

192.168.0.2

5. If successful, the ping utility will respond that packets were sent, received and how

long it took. For example:
64 bytes from 192.168.0.2: icmp_seq=0 ttl=64 time=0.590 ms

6. If unsuccessful, check Ki Pro’s network settings and resolve the problem with your IT

administrator.

Controlling Ki Pro
from a web-browser

To control Ki Pro from a web-browser on a network attached computer, you must enter Ki
Pro’s IP address as a URL in the browser. For example, if Ki Pro’s IP address were “10.0.6.31”,
you would then type into the web browser: http://10 .0.6.31

This topic is explained in greater detail in Chapter 4: Browser Remote Control.

Controlling Ki Pro
via 802.11b/g

Another option for remote control is Ki Pro’s built-in 802.11 wireless transceiver which
can communicate with properly configured 802.11 wireless access points such as an
Airport Basestation or 802.11 wireless router.

You can enable or disable wireless control of Ki Pro for security. Further, you can select a
type of wireless security to match other devices; popular methods such as WEP, WPA and
WPA2 are supported. To use wireless control you’ll follow this basic process:

• Enable wireless control of Ki Pro

Advertising