AJA Ki Pro - Manual (Page 43)

Ki Pro v3.2 www.aja.com 43
2. Press the SELECT up or down arrow button repeatedly until you find the clip you are
looking for.
3. Press the PLAY (>) button.
4. When playing back a clip (PLAY, FF, or REV) the first push of STOP acts as a “Pause”
mode: the playback is paused, the current point of the clip is displayed, and the STOP
button will flash. A second push of STOP will completely stop the playback and Ki
Pro's outputs will go into an “E to E” mode (the currently selected inputs will be
bypassed to the outputs). When a playback reaches the end of a clip, it will
automatically pause on the last frame of the clip.
During playback you can use the FFWD, REV, SELECT, or ADJUST buttons as follows:
FFWD (>>): Press button to begin fast playback of the current clip at 2x speed. Successive pushes
increase the speed to 4x, 8x, and 16x. (Pushing the button after 16x speed is reached has
no further effect.) When fast-forwarding, audio is muted.
REV (<<): Pressing REV when not lit, begins playback of the current clip in reverse at 1x speed.
Successive pushes increase the speed to 2x, 4x, 8x, and 16x. (Pushing the button after 16x
speed is reached has no further effect.) When playing in reverse, audio is muted for all
speeds.
SELECT (up/down): While in TRANSPORT mode, the SELECT buttons select clips and operate like “previous”
and “next” keys. When a clip is selected it is “cued” to the beginning of the clip. Note that
ordering and playback of clips is based on timestamp order, not clip name. If you have
paused playback (the STOP button is flashing), you can use the SELECT down button to
jump back to the beginning of the clip. If the STOP button is not flashing, depressing the
SELECT down button will select the previous clip.
ADJUST (up/down): While in TRANSPORT mode, and in either a “STOP” or “pause” state, the ADJUST buttons
will “single step” the current clip at a rate of one frame per button push (up=forward,
down=reverse).
Deleting Clips
To delete a previously recorded clip:
1. In TRANSPORT mode, use the SELECT up and down arrow buttons to browse through
the clips on the current storage device.
2. When you find a clip you want to delete, press the DELETE CLIP button.
3. Ki Pro will ask “Are you sure”—press the ADJUST up arrow button to confirm deletion.
Pressing the down arrow, or any other button, will abort the deletion.
STATUS menus
The STATUS menus display I/O status and Alarm information. The STATUS menu can be
accessed almost anytime and will not change any active transport modes. Like the
CONFIG and MEDIA menus, STATUS display screens can be viewed by pushing the
SELECT up or down buttons. Pressing STATUS will exit the screens and return to
TRANSPORT mode, where an action could still be occurring (like playback or even
recording).
Record and Play Modes Line 1: Status (Record) displays the input format; the 4 characters on the right display the
selected input video format: SDI, CMP, HDMI. Status (Play) displays the media format.