AJA Ki Pro - Manual (Page 65)

Ki Pro v3.2 www.aja.com 65
41.1 VIDEO SG FRMT This parameter determines the video format output from Ki Pro’s internal test signal
generator. This parameter is used with parameter 41.2 to determine the type of video
test signal output by Ki Pro. These are the options:
41.2 VIDEO SG This parameter determines the video signal output from Ki Pro’s internal test signal
generator. This parameter is used with parameter 41.1 to determine the type of video
test signal output by Ki Pro. These are the options:
41.3 AUDIO SG This parameter determines the audio signal output from Ki Pro’s internal test signal
generator. These are the options:
50.1 IP CONFIG This parameter determines the type of TCP/IP network configuration used by Ki Pro:
525i 29.97 (default)
625i 25
720p 50
720p 59.94
1080p 23.98
1080i 25
1080i 29.97
720p 60
1080PsF 23.98
1080PsF 24
1080i 30
1080p 24
1080p 25
1080p 29.97 Select the video format desired for test signal output.
OFF (default)
Black
75% Bars
100% Bars
Turn test signal output OFF.
Video test signal output is color black.
Video test signal output is 75% color bars. This 75%
amplitude,100% saturation test signal is useful to check
low frequency response and video tilt as well as the
performance of video clamping.
Video test signal output is 100% color bars. This 100% white
full field bars test signal is helpful to check chroma
amplitude versus overall video level.
OFF (default)
Silence
1 kHz Turn audio test signal output OFF.
Output an audio test signal containing silence only.
Output a standard 1 kHz test signal tone.
STATIC ADDR
DEFAULT ADDR
DHCP (default)
Assign a static IP address manually (parameters 50.2,
50.3, and 50.4 will have to be entered to accomplish
this).
Use the factory default static IP address: 10.65.74.65
Select automatic IP address assignment from DHCP
server on LAN.
NOTE: If Ki Pro cannot find a DHCP server to communicate
with, it will select the default factory IP address of
192.168.0.2.