ATIK Cameras 11000 Quick Start - Manual (Page 4)

Page 2
Setting up your camera
Installation of the camera is very straightforward, and by following
this guide you will be up and running with a minimum of effort.
Your camera is supplied with a 3 metre USB cable and a .8 metre
power cable with a car lighter plug. The car lighter plug will allow
you to connect the camera to most power tanks and emergency
battery packs available on the market today for field use.
An optional universal mains adaptor is also available, allowing you
to run the camera from a 0/220V mains supply. We recommend
that you purchase the approved mains adaptor if you intend to
power the camera this way.
If you wish to supply your own adaptor, make sure it’s of good
quality, with a 2.mm type plug, center positive, and capable of
supplying a minimum of .5 amp (Atik Titan/34/320), or 2.5 amp
(Atik 383/4000/000).
WARNING: Mains power adaptors are intended for indoor or
observatory use only. There is a risk of electric shock if the adaptor
is used in damp environments or outside. If in doubt do not use the
adaptor and consult a trained electrician.