Autocue SSPi - Manual

Guide
Straight-read Assembly
SSPi
iPhone Prompter
1. Place your SSPi on a smooth, level
surface. Remove the thumbscrews holding
the hood and iPhone mounting plate.
2. Remove the two thumbscrews
attaching the iPhone mounting
bracket to the drop bracket.
3. Remove the knob securing the
iPhone carrier to the iPhone
carrier mounting bracket.
4. Align the bolt on the back of the
iPhone carrier with the hole in the
centre of the drop bracket.
5. Secure it to the drop plate
with the knob.
6. Attach an optional pistol
grip to the hot shoe plate on
the underside of the SSPi unit.
7. Now attach your camera
to the camera mounting
bracket using the screw
supplied.
Camera screw
Mount the camera to the camera mounting bracket
using the 1/4” BSW camera screw, slide the camera
forward and ensure that the lens is inside the hood.
Use the hood slide screw to centre the lens inside
the hood and place the black light excluder around
the lens. Secure it using the drawstring.
Mounting the Camera
Camera Balancing
Loosen the two screws
(marked
A in the picture) so
that the hot shoe plate will
slide back and forth. A
A
Mount the unit with
camera attached to the
tripod and slide the unit
back and forth until you
achieve a balance
.
Then retighten the
screws.
autocue.com