Care and maintenance, Notice – Bosch SHE4AM User Manual

Page 14

Advertising
background image

14

Sanitized Light

When the sanitized light appears, it means that the dishware and kitchenware that was
just washed has been sanitized according to the requirements of the national sanitation
Foundation (NSF). For more information on NSF certification, refer to the Wash Cycle
information section of this manual.

Unloading the Dishwasher

Unload the bottom rack first.

unload the silverware basket(s). they are easily removed for unloading.

unload the top rack.

Care and Maintenance

Maintenance Tasks

Certain areas of your dishwasher require occasional maintenance. the maintenance tasks
are easy to do and will ensure continued superior performance from your dishwasher.
these tasks are:

• Winterizing Your Dishwasher

• Wiping up Spills and Splash-out

• Clean the Stainless Steel Inner Door and Tub

• Check/Clean the Spray Arm Nozzles

• Check/Clean the Filter System

• Clean the Exterior Door Panel

• Clean the Door Gasket

Winterizing Your Dishwasher

if your dishwasher will be unused for an extended period of time in a location that experiences
freezing temperatures (e.g., in a holiday home or through a vacation period), have your
dishwasher winterized by an authorized service center.

NOTICE

To avoid dishwasher damage, do not allow water to remain in your dishwasher sys-

tems through extended periods of freezing temperatures. Freezing temperatures can
damage your dishwasher.

Wiping Up Spills and Splash-out

Water may occasionally splash out of your dishwasher, especially if you interrupt a cycle or
open the dishwasher door during a cycle. To avoid floor damage and possible mold growth,
do not allow wet areas to remain around or under the dishwasher.

Check/Clean the Stainless Steel Inner Door and Tub

Clean the outer edges of the inside door panel regularly to remove debris that might collect
there from normal loading.

if spots begin to appear on the stainless steel tub or inner door, make sure the rinse agent
reservoir is full.

Check/Clean the Spray Arm Nozzles

occasionally check the spray arms to ensure that the spray arm nozzles (holes) are
unobstructed. You must remove the spray arms to check them for obstruction.

Figure 17

Figure 18

Figure 19

A

B

Advertising
This manual is related to the following products: