Boomba Racing Ford Fiesta ST Transmission Adapter - Manual

FORD FIESTA ST
SHIFTER PLATE
8 Pry off the shifter cable from the shifter
arm with the flat head screw drivers.
9 Boomba Shifter Plate ready for
installation.
The extra hole in the bottom plate should
be on the same side that the pivot ball
during installation.
10
Slide the Boomba Shifter Plate over the
shifter arm.
11
Secure the shifter plate to the bottom
plate with provided screws. Reconnect the
shifter cable.
12
Reinstall the air supply tube, the vent line
and the air filter box. Tighten all hose
clamps and bolts. Reconnect the MAF
sensor.
MATERIALS REQUIRED
None
TOOLS REQUIRED
M7 socket wrench
M10 socket wrench
T25 Torx bit
Large flat screw driver Large flat screw drivers
1 Remove plastic vacuum hose from rubber
adaptor on the top of valve cover (leave
rubber adaptor in place). 1 Disconnect the MAF sensor. 2 Remove the air filter cover. 3 Remove the air filter. 4 Remove the vent line.
5 Loosen the air pipe clamp and remove the
air pipe. 6 Snap off the air supply duct from the latch. 7 Remove the air box.