Brandmotion 9002-6005 - Manual

9002-6005 – Denali Jumper Harness
1. Remove the brown C12 connector from the MBEC.
2. Remove the TPA from the C12 connector.
3. Install pink wire from the mirror or NAV harness, supplied in complete RVS kit, into one
of the larger connector cavities.
4. Remove pink wire from cavity 7 of the C12 connector.
5. Install pink wire into the other cavity of larger connector.
6. Slide gray TPA inside the larger connector to lock wires into place.
7. Mate larger connector into smaller connector (with pink wire)
8. Insert pink wire from the smaller connector into cavity 7 of the C12 connector (where
pink wire was removed).
9. Reinsert the TPA and connector into the M-BEC
9002-6005 – Denali Jumper Harness
1. Remove the brown C12 connector from the MBEC.
2. Remove the TPA from the C12 connector.
3. Install pink wire from the mirror or NAV harness, supplied in complete RVS kit, into one
of the larger connector cavities.
4. Remove pink wire from cavity 7 of the C12 connector.
5. Install pink wire into the other cavity of larger connector.
6. Slide gray TPA inside the larger connector to lock wires into place.
7. Mate larger connector into smaller connector (with pink wire)
8. Insert pink wire from the smaller connector into cavity 7 of the C12 connector (where
pink wire was removed).
9. Reinsert the TPA and connector into the M-BEC
9002-6005 – Denali Jumper Harness
1. Remove the brown C12 connector from the MBEC.
2. Remove the TPA from the C12 connector.
3. Install pink wire from the mirror or NAV harness, supplied in complete RVS kit, into one
of the larger connector cavities.
4. Remove pink wire from cavity 7 of the C12 connector.
5. Install pink wire into the other cavity of larger connector.
6. Slide gray TPA inside the larger connector to lock wires into place.
7. Mate larger connector into smaller connector (with pink wire)
8. Insert pink wire from the smaller connector into cavity 7 of the C12 connector (where
pink wire was removed).
9. Reinsert the TPA and connector into the M-BEC