CAA RONI User Manual

New product, Roni pistol carbine assembly instructions, Roni features & accessories

Advertising
background image

MAKE SURE THE PISTOL IS UNLOADED AND THE CHAMBER IS EMPTY BEFORE INSTALLING.

PRACTICE SAFE FIREARM HANDLING PROCEDURES AT ALL TIMES.

YOU MUST READ AND FOLLOW THE MANUAL. FOR MORE INFORMATION VISIT OUR WEBSITE.

2

1

Remove the 2 locking pins

(#1)

&

(#2)

by first pushing

them from the right side of the RONI. You will then be

able to pull the locking pins from the left side of the

RONI. NOTE: The locking pins have detents to prevent

them from being pulled out completely.

Step 1.

Lay the RONI down on its right side. The muzzle should
be pointed to the left. Pull the front barrel housing end
cap

(#6)

to the left by grasping onto the finger guard and

forward grip. Pull the rear housing end cap

(#7)

to the

right. This will fully expose both ends of the hinged pistol
housing.

(#8)

Step 4.

Grasp stock, press the stock extension button

(#14)

on

rear of stock and pull back on carbine stock to extend
stock to its longest position.

Step 2.

RONI Pistol Carbine Assembly Instructions

WARNING: The addition of the RONI stock set to a pistol results in the

manufacture of a short barreled rifle (SBR) which the classification of a

firearms subject to NFA controls (Section 5845(a)(3). The manufacture of

SBR’s is generally lawful when preformed after the receipt of a properly

submitted ATF Form 1(Application to make and register a firearm) and

submission of a $200.00 making tax payment. . BATF Classification

Letter - May 6, 2010

14

7

6

8

5 position buttstock adjusts for length of pull

Cheek rest adjusts for height

Spare magazine holder

OPS / OPS1 - One Point Slings

PBSS - Push Button Sling Swivel

Features two aluminum Picatinny rails for additional light/laser

mount.

RBCG1 (GLOCK) / RBCF (Other Models) - Optional Brass Catcher

Accepts suppressors - up to 1.39” diameter

PLS1 / PLS34 - 1” or 3/4” Low profile offset polymer light mounts

PLS1Q / PLS34Q - 1” or 3/4” Quick detach low profile offset

polymer light mounts

AL1 / AL34 / AL134 - 1” or 3/4” or 1 + 3/4” Offset aluminum light

mounts

New Product

FFS / FRS - Front & Rear Flip Up Sights. No tools necessary to

adjust front sight

Features Detachable folding forearm grip

RONI FEATURES & ACCESSORIES

1-866-611-9576 / WWW.COMMANDARMS.COM
215-949-9944 / WWW.EMATACTICAL.COM

RONI CASE - A lockable place to store your RONI with

accessories. Case Dimensions - 12” x 21.5” x 4”

Step 3.

4

5

Open the foregrip

(#4)

to a vertical position by pushing

the release button on the side

(#5)

and pull the grip

down into a vertical position.

WARNING:

State and local laws supersede

NFA controls. Title 27 CFR Chapter ll Section 479.52.

Advertising