ClearCube PCoIP System User's Guide User Manual
Pc-over-ip, Pcoip, System user’s guide
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Chapter 1. Introduction
- Chapter 2. Connection Modes and Network Topology
- Chapter 3. Network Considerations
- Chapter 4. Initial Setup
- Chapter 5. Zero Client Controls and Supported Power States
- Chapter 6. Configuring Devices, Setting Peers, and Connecting
- 6.1 Finding a Device’s IP Address and MAC Address
- 6.1.1 External IP Address Is Not the PCoIP Processor IP Address
- 6.1.2 Finding an IP Address or MAC Address Using ClearCube Sentral
- 6.1.3 Finding Zero Client IP or MAC Address Using OSD
- 6.1.4 Finding a Device’s IP Address Using a TCP/IP Port Sweep
- 6.1.5 Using Default Device Fallback IP Addresses
- 6.1.6 More about Device IP and MAC Addresses
- 6.2 Configuring Zero Clients and Host Cards
- 6.3 Using the Web Interface
- 6.4 Configuring Blades
- 6.5 Specifying a Device’s Peer
- 6.6 Connecting to a Device
- 6.7 Configuring Video Settings
- 6.8 Managing Sessions (Connections) and Device Behavior
- 6.1 Finding a Device’s IP Address and MAC Address
- Chapter 7. Changing Device Peers
- Chapter 8. Mass Storage Lockout (MSL)
- Chapter 9. Updating Device Firmware
- Appendix A: Best Practices
- Appendix B: Troubleshooting
- Can’t set or change peer for a device
- Resolution
- “No route to host” message
- Resolution
- PCoIP does not support all power states
- Resolution
- Host cards do not respond to ARP requests
- Resolution
- Connected to 100-Mbit, full-duplex switch: poor performance, not full-duplex
- Zero client does not connect to blade (DHCP disabled or IP address changed)
- Resolution
- USB device connected to zero client, gray dialog box displayed
- Resolution
- Zero client video degrades or displays do not work
- Resolution
- Poor or no audio on a host running a 64-bit OS
- Resolution
- Appendix C: PCoIP Management and ClearCube Sentral
- Appendix D: Zero Client and Host Card Web Interfaces