DJI Phantom 2 Prop Guard Attachment User Manual

Phantom 2, Prop guard attachment instructions, 桨保护器安装说明

Advertising
background image

©2013-2014

DJI Innovations. All Rights Reserved.

|

PHANTOM 2

Prop Guard Attachment Instructions

V1.00

PHANTOM 2

桨保护器安装说明

V1.00

Please follow the below instructions to attach your Phantom 2 Prop Guards.

请按照下面步骤安装桨保护器。

1.

Gather together the Phantom 2, Prop Guards (4), M3x12 screws (8), thread and an Allen key.

准备 PHANTOM 2 飞行器,桨保护器(4 个),M3x12 螺丝(8 颗),保护线,内六角螺丝刀。

2.

Remove the M3x8 screws under each of the four motors (Fig.1).

按照图 1 所示,使用螺丝刀卸下原 PHANTOM 2 四个电机上的 M3x8 螺丝。

3.

Place the Prop Guards and attach them with the M3x12 screws (Fig.2). Tighten as required. Do this for all four

Prop Guards. Do not use thread lock.

按照图 2 所示,适当用力拧紧 M3x12 螺丝,装好四个 PHANTOM 2 桨保护器。不可以使用螺丝胶。

4.

Improve protection further by attaching a thread through the Prop Guards. This thread should go under the

Prop Guards (Fig.3).

按照图 3 所示,为起到更好的保护作用,将保护线连到桨保护器上,注意穿线时将线绕在桨保护器底部。

IMPORTANT

:

M3x12 screw is only for Prop Guard assembly. Without a Prop Guard, use M3x8 screw to avoid

damaging the motor.

注意

此处安装桨保护器,使用型号为 M3x12 的螺丝;如果没有安装桨保护器,只能使用型号为 M3x8 螺

丝。否则,过长的螺丝会损坏电机。

Fig.1

Removing Screws

/

图 1

卸下原螺丝

Fig.2

Prop Guard Attachment

/

图 2 安装桨保护器

Fig.3

Complete

/

图 3 正确安装示意图

Specifications/

参数

Weight (Single)/

重量(单个):21g

Angle/

角度:150.0

o

Radius/

半径:128.25mm

Whole Size with Four Prop Guards/

安装后

最大外形尺寸:613mm

Advertising