Bissell QuickSteamer 1770 series - Manual (Page 6)

O
peration
Carpet cleaning
1. With your foot, press the red power switch
[located in foot of unit] ON .
2. With foot, press the detent lever on left side of
lower body.
3. Depress spray trigger to spray cleaning solution.
Do not overwet.
4. To suction up water, repeat motion over same
area without pressing trigger.
5. Repeat steps 3 and 4 until no more dirt can be removed.
6. Continue to clean entire carpet, working in
3’ x 4’ sections.
7. Empty the collection tank when dirty water reaches
the full line, or when the solution tank is empty.
8. If floor nozzle stops spraying, turn power switch
OFF and check water and cleaning solution levels.
Refill if needed.
To empty the collection tank
1. Turn power switch OFF and unplug power cord
from outlet.
2. Remove and empty collection tank.
a. Release collection tank latches [1 each side] by
pulling up from bottom of latch and then out.
b. Carefully remove collection tank from
lower body by lifting handle.
c. Carry collection tank to a toilet or sink. To
empty, pour out contents using opening at
back of tank.
d. Rinse collection tank thoroughly.
e. Remove lint and hair from red gasket in
base of unit. (Do not remove gasket)
3. Clean nozzle window by lifting latch and removing
from machine. Rinse under running water. When
finished replace nozzle and secure with latch.
4. Replace collection tank on lower body and secure
with latches.
6
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
Tip:
It is recommended
that every time your
solution tank needs
refilling, that you empty
the contents of the
collection tank. If the
collection tank gets too
full, you may begin to
see foam spitting out
of the vent cover. If this
happens empty the
collection tank.
2a.
3
2c.
2b.
2e.