The oven, Table 12: oven troubleshooting chart – Bosch Gas Ranges User Manual

Page 41

Advertising
background image

Service

English 39

The Oven

Uneven or too high flame;
burner is hard to light

Burner ports are clogged. Turn the cooktop off and allow the burners to cool.
Remove burner caps and use a stiff nylon bristle toothbrush to push debris through
burner ports.

Misaligned burner cap. Verify that burner caps are properly positioned over burn-
ers.

Burner cap is wet. Turn off burner and allow to cool. Dry burner cap and base thor-
oughly.

Uneven flame - LP gas users

Call service

Table 11: Cooktop Troubleshooting Chart

Cooktop Problem

Possible Causes and Suggested Solutions

Table 12: Oven Troubleshooting Chart

Oven Problem

Possible Causes and

Suggested Solutions

The oven mode or temperature selected
or the numbers selected do not appear in
the display

The knob was turned too rapidly. Turn knob slower until correct wording or
temperature appears. Review manual instructions when setting clock,
timer, or Self-Clean.

Oven door is locked and will not release,
even after cooling

Turn the oven off at the circuit breaker and wait 5 minutes. Turn breaker
back on. The oven should reset itself and will be operable.

Oven is not heating

Check circuit breaker or fuse box to your house. Make sure there is proper
electrical power to the oven. Be sure oven temperature has been selected.

Oven is not cooking evenly

Adjust oven calibration if necessary (see “Change the Oven Temperature
Offset” on page 14
). Refer to cooking charts for recommended rack posi-
tion.

Baking results are not as expected

Refer to cooking charts for recommended rack position. Check “Getting the
Most Out of Your Oven” on page 24
for tips and suggestions. Adjust oven
calibration if necessary (see “Change the Oven Temperature Offset” on
page 14)
.

Food takes longer to cook than expected

The oven is carefully calibrated to provide accurate results. However, the
temperature can be offset if food is consistently too brown or too light. See
“Change the Oven Temperature Offset” on page 14.

Food is overcooked

The oven is carefully calibrated to provide accurate results. However, the
temperature can be offset if food is consistently too brown or too light. See
“Change the Oven Temperature Offset” on page 14.

Convection Bake Results are not as
expected

If the Automatic Convection Conversion Feature is turned off, the tempera-
ture must be manually reduced by 25°F. If the feature is active, the temper-
ature is automatically adjusted. See “Turn Automatic Convection
Conversion ON or OFF” on page 15
for more information. Refer to cooking
charts and tips for rack positions, cooking times and pan selection. Adjust
oven calibration if necessary. See “Change the Oven Temperature Offset”
on page 14.

Oven temperature is too hot or too cold

The oven thermostat needs adjustment. See Oven Temperature Offset.

Oven light is not working properly

Replace or reinsert the light bulb if loose or defective. Touching the bulb
with fingers may cause the bulb to burn out.

Advertising