Brother HL-1800 series - Manual (Page 99)

CHAPTER 3 CONTROL PANEL
3-31
! List of Factory Settings
The following table shows the initial factory default settings.
✒ ✒ ✒ ✒ Note
• The settings are subject to the emulation mode. Effective modes are
indicated in parentheses in the following table.
• The following settings cannot be restored to the factory settings with the
RESET menu in the “FACTORY SETTINGS” mode: INTERFACE MODE,
HRC SETTING, PAGE PROTECTION, SCALABLE FONT, LOCK
PANEL, PAGE COUNTER and local language for display messages.
• The COPY setting is always restored to the factory setting when the
printer is turned off and on again.
• It is not possible to reset the NETWORK settings from the Control panel.
If you wish to reset the print server back to its default factory settings
(resetting all information such as the password and IP address
information) hold down the Network Test Button of the Network board
(NC-4100h) for more than 5 seconds.