Behringer 1 - Manual (Page 13)

13 EUROPOWER PMP1680S/PMP980S/PMP960M User Manual
Specifications 6.
Microphone Inputs
Type XLR, electronically balanced input circuit
Mic E.I.N. (20 Hz - 20 kHz)
@ 0 Ohm source resistance -112 dB / 114 dB A-weighted
@ 50 Ohm source resistance -112 dB / 114 dB A-weighted
@ 150 Ohm source resistance -112 dB / 114 dB A-weighted
Frequency response
< 10 Hz - 200 kHz (-1 dB)
< 10 Hz - > 200 kHz (-3 dB)
Gain +30 dB, +10 dB with pad
Max. input level +12 dBu @ +10 dB gain
Impedance approx. 2.2 kOhm balanced /
approx. 1.1 kOhm unbalanced
Signal-to-noise ratio 110 dB / 114 dB A-weighted
(0 dBu In @ +10 dB gain)
Noise (THD + N) 0.001% / 0.0007% A-weighted
Mono Line Inputs
Type ¼" TS connectors, balanced
Impedance approx. 20 kOhm, balanced
Max. input level +21 dBu
Stereo Line Inputs
PMP980S/PMP1680S
Type ¼" TRS connectors, unbalanced
Impedance approx. 100 kOhm, unbalanced
Max. input level +21 dBu
Equalizer
Low 80 Hz / +/-15 dB
Mid 2.5 kHz / +/-15 dB
High 12 kHz / +/-15 dB
CD/TAPE Input
Type RCA
Impedance approx. 10 kOhm
Preamp Outputs
MAIN
Type ¼" TS connectors, unbalanced
Impedance approx. 150 Ohm, unbalanced
Max. output level +21 dBu
MONITOR
Type ¼" TS connectors, unbalanced
Impedance approx. 150 Ohm, unbalanced
Max. output level +21 dBu
Stereo Outputs
PMP960M
Type RCA, mono output
Impedance approx. 1 kOhm
Max. input level +21 dBu
PMP980S/PMP1680S
Type ¼" TRS connectors, unbalanced
Impedance approx. 150 Ohm, unbalanced
Max. input level +21 dBu
Type RCA
Impedance approx. 1 kOhm
Max. input level +21 dBu
Main Mix System Data
Noise:
MAIN MIX @ -∞ -102 dB/-106 dB A-weighted
Channel fader -∞
MAIN MIX @ 0 dB
-88 dB/-91 dB A-weighted
Channel fader -∞
MAIN MIX @ 0 dB
-84 dB/-86 dB A-weighted
Channel fader @ 0 dB
Loudspeaker Outputs
Type Neutrik Speakon-compatible connector
Load impedance:
MAIN L/R 4 - 8 Ohm
MONITOR/MAIN MONO 4 - 8 Ohm
MAIN MONO/MAIN MONO 4 - 8 Ohm
BRIDGE 8 - 16 Ohm
DSP
Converter 24-bit Delta-Sigma,
64/128-times oversampling
Dynamics D/A 90 dB
Sampling rate 40 kHz
Delay Time max. 5 secs
Signal run time approx. 1.5 ms
(Line In > Line Out)
Display
PMP960M
Type 2-digit, 7-segment LED
PMP980S/PMP1680S
Type 2 x 2-digit, 7-segment LED