Behringer 1 - Manual (Page 9)

9 EUROPOWER PMP1680S/PMP980S/PMP960M User Manual
Digital Effects Processor 3.
24-BIT MULTI-EFFECTS PROCESSOR
This built-in effects module produces high-grade standard effects such as
reverb, chorus, flanger, delay and various combination effects. The integrated
effects module has the advantage of requiring no wiring. This way, the danger
of creating ground loops or uneven signal levels is eliminated at the outset,
completely simplifying the handling.
These effect presets are designed to be added to dry signals. If you move the
FX RET control, you mix the channel signal (dry) and the effect signal.
Turn down the FX controls in those channel strips whose signals you ◊
don’t wish to process.
Installation 4.
Mains connection 4.1
Blown fuses must be replaced by fuses of the same type and rating.
The mains connection is made using the enclosed power cord and a standard IEC
receptacle. It meets all of the international safety certification requirements.
Please make sure that all units have a proper ground connection. ◊
For your own safety, never remove or disable the ground conductor
from the unit or of the AC power cord.
Audio connections 4.2
The inputs and outputs of the BEHRINGER EUROPOWER are unbalanced ¼" TS
connectors—except for the balanced mono line inputs. Of course, all inputs and
outputs work with both balanced and unbalanced connectors. The Tape Ins and
Outs are on stereo RCA connectors.
Please ensure that only qualified personnel install and operate the ◊
power mixer. During installation and operation, the user must have
sufficient electrical contact to earth. Electrostatic charges might affect
the operation of the unit.
Strain relief clamp
Sleeve
Tip
Sleeve
(ground/shield)
Unbalanced ¼" TS connector
Tip
(signal)
Fig. 4.1: ¼" TS connector
strain relief clamp
sleeve
ring
tip
sleeve
ground/shield
For connection of balanced and unbalanced plugs,
ring and sleeve have to be bridged at the stereo plug.
Balanced ¼" TRS connector
ring
cold (-ve)
tip
hot (+ve)
Fig. 4.2: ¼" TRS connector
output
For unbalanced use, pin 1 and pin 3 have to be bridged
1 = ground/shield
2 = hot (+ve)
3 = cold (-ve)
input
1 2
3
1 2
3
Balanced use with XLR connectors
Fig. 4.3: XLR connectors