Briggs & Stratton Ferris 27HP User Manual

Installation instructions, Warning, Installation

Advertising
background image

1

Briggs & Stratton Yard Power Products Group
Copyright © 2006 Briggs & Stratton Corporation
Milwaukee, WI, USA. All Rights Reserved.

5402677

Rev.12/2006

TP 200-7322-00-SK-FS

WARNING

Before beginning any service work turn off the
PTO, set the parking brake, turn off the ignition,
and disconnect the spark plug wire(s).

INSTALLATION

1. Park machine on a flat, level surface and engage the

parking brake. Disengage the PTO switch, turn off
the engine and remove the key from the ignition.

2. Remove the PTO clutch belt.

3. Cut the tie wrap that secures the PTO clutch wires

(E, Figure 1) to the PTO clutch anchor bracket (G).
Disconnect the PTO clutch wires from the main wire
harness.

4. Remove the 5/16” nylock flange nut (D) that secures

the PTO clutch anchor pad (F) to the PTO clutch (B).

NOTE: Before removing the PTO clutch observe and
remember the clutch orientation to the clutch anchor pad
for reinstallation later.

5. Loosen and remove the crankshaft bolt (C), the PTO

clutch (B) and the crankshaft spacer (A). Discard the
old crankshaft bolt and the old spacer.

6. Install the new crankshaft spacer with the rounded

edge on the inside of the spacer facing up toward the
pulley (H). Reinstall the PTO clutch in the same
orientation that it was removed in Step #5 and
secure with the new crankshaft bolt. Torque the
crankshaft bolt to 65 ft-lbs (88Nm).

7. Reinstall the 5/16” nylock flange nut to secure the

PTO clutch anchor pad to the PTO clutch.

8. Reconnect the PTO clutch wires to the main wire

harness. Pull the wire slack away from all belts and
pulleys and secure to the PTO clutch anchor bracket
with the tie wrap.

9. Reinstall the PTO clutch belt.

Installation

Instructions

Engine Spacer Replacement Kit

Part No. 5600094

For Ferris 27HP Kohler IS2000Z Models and Simplicity Cobalt Models

Kit Contents:

Part No.

Qty.

Description

5044062

1

Spacer, 1.13 X 1.75 X .50

5045289

1

Bolt, Crankshaft, 7/16 X 2-1/2”

5021029

1

Tie Wrap, 11” long

Figure 1. Replacing the Engine Spacer
A. Crankshaft Spacer
B. PTO Clutch
C. Crankshaft Bolt
D. 5/16” Nylock Flange Nut
E. PTO Clutch Wires
F. PTO Clutch Anchor Pad
G. PTO Clutch Anchor Bracket

C

B

A

D

E

F

G

H

Advertising