Krell S-350av - Manual

Note
Save all packing materials.
If you need to ship the S-350 in the
future, repack the unit in its original
packaging to prevent shipping
damage.
S-350
CD/DVD Player
QUICK SETUP GUIDE
Getting Started
KRELL
THE LEADER IN AUDIO ENGINEERING
Thank you for your purchase of the Krell S-350. The S-350 CD/DVD Player is a modular
design featuring reference caliber CD playback as well as an optional state-of-the-art
video engine that provides stunning 1080p performance and video processing controls.
The S-350 can be outfitted with different outputs to match the requirements of any high
performance audio or home theater system.
Configurations include:
• S-350a - High performance CD player with balanced analog outputs
• S-350av - Complete package including audio and video options
Please contact your authorized dealer, distributor, or Krell if you have any questions not
addressed in the owner’s reference.
Do not place the compact disc player where it could be exposed to dripping or splashing.
Do not remove or bypass the ground pin on the end of the AC cord. This may cause radio
frequency interference (RFI) to be introduced into your playback system.
The ventilation grids on the top and bottom of the S-350 must be unobstructed at all times during
operation. Do not place flammable material on top of or beneath the component.
Turn off all systems' power before connecting the S-350 to any component. Make sure all cable
terminations are of the highest quality, free from frayed ends, short circuits, or cold solder joints.
Caution: Visible and invisible laser radiation. When the cover is open, avoid exposure to beam.
This unit employs a laser. To prevent possible eye injury, only a qualified service person should
remove the cover or attempt to service this device. Use of controls or adjustments or performance
of procedures other than those specified herein may result in hazardous radiation exposure.
THERE ARE NO USER-SERVICEABLE PARTS INSIDE ANY KRELL PRODUCT.
1. Open the shipping box and remove the top layer of foam. You see these items:
2. Grasp the underside of the foam end-caps that encase the S-350 and lift it straight out
of the shipping box.
3. Place the S-350 in a safe location and remove the protective plastic wrapping.
Place the S-350 on a firm, level surface, away from excessive heat, humidity, and
moisture. The S-350 requires at least two inches (5 cm) of clearance on each side and
at least two inches (5 cm) of clearance above and below the component to provide
adequate ventilation. Installations inside cabinetry may need extra ventilation.
Do not place the S-350 near hum sensitive components such as preamplifier phono
stages or turntables. Although the S-350 is well shielded, placing it near these
components could create interference and cause hum.
The S-350 has superb regulation and does not require a dedicated AC circuit. Avoid
connections through extension cords or multiple AC adapters. High
quality 15 amp grounded AC strips are acceptable. High quality AC line conditioners may
be used if they are grounded and meet or exceed the unit's power supply rating of 50 VA.
WARNINGS
Krell S-350 1
Unpacking
Krell Industries, LLC., 45 Connair Road,Orange, CT 06477-3650 USA
TEL 203-799-9954, FAX 203-891-2028, E-MAIL [email protected]
WEB SITE http://www.krellonline.com
Connecting the S-350
to Your System Follow these steps to connect the S-350 to your system.
1. Make sure all power sources and components are off before connecting
inputs and outputs.
2. Neatly organize the wiring between the S-350 and all system components.
Separate AC wires from audio cables to prevent hum or other unwanted
noises from being introduced into the system.
3. Balanced outputs use three-pin XLR connectors. Single-ended outputs use
RCA connectors. Maintain the correct left/right orientation of these outputs.
4. To play DVD discs (S-350av), connect desired video output to
preamp/processor or display's video input. For use with a
preamplifier/processor, connect digital audio output to digital audio input.
5. For two-channel compact disc playback only, connect the S-350 digital audio
outputs to the D/A convertor or preamplifier/processor digital input or
balanced/single-ended analog audio outputs to the preamplifier balanced or
single-ended analog audio inputs.
6. Plug the AC power cord into the IEC power connector on the back panel.
Then plug the AC power cord into the wall socket.
Press the back panel power switch (35) labeled “1”. When the S-350 is initialized
and in the stand-by mode, the red stand-by LED (2) on the front panel
illuminates. Then press the power button on the front panel or the power key (1)
on the remote control, to place the S-350 in the operational mode. When the
blue power LED (2) illuminates, the S-350 is in the operational mode.
1. Insert disc into the slot
2. Press the play button or key. The format type is visible in the front panel
display. The format type disappears and the front panel display reads TRACK
1 and the track time, as the disc begins playing.
3. Adjust the volume level through your system volume control.
4. Press the stop button or key to end disc playback.
5. Press the play button or key (6) to begin playback again, from the first track.
6. To return the S-350 to the stand-by mode, press the power button or key (1).
1. Do not install near any heat sources such as radiators, heat registers, stoves,
or other apparatus (including amplifiers) that produce heat.
2. Unplug this apparatus during lightning storms or when unused for long
periods of time.
3. Refer all servicing to qualified service personnel. Servicing is required when
the apparatus has been damaged in any way, such as a power-supply cord or
plug is damaged, liquid has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain or moisture, does not
operate normally, or has been dropped.
4. The ventilation grids on the top of the apparatus and the space underneath it
must be unobstructed at all times during operation. Do not place flammable
material above or beneath the apparatus.
5. Before making connections to the Evolution 505, ensure that the power is off
and other components are in mute or stand-by mode. Make sure all cable
terminations are of the highest quality, free from frayed ends, short circuits, or
cold solder joints.
Please contact Krell if you have questions not addressed in this guide.
4 Krell S-350
Licensing attributions:
Manufactured under license from Dolby Laboratories.
Dolby is a trademark of Dolby Laboratories.
Manufactured under license under U.S. Patent #'s:
5,451,942; 5,956,674; 5,974,380; 5,978,762;
6,487,535 & other U.S. and worldwide patents issued
& pending. DTS and the Symbol are registered
trademarks & DTS Digital Surround and the DTS
logos are trademarks of DTS, Inc. Product includes
software. © DTS, Inc. All Rights Reserved.
Safety notices:
This CLASS I apparatus must be
connected to a MAINS socket outlet
with a protective earthing
connection.
Operating the S-350
This product complies with the EMC directive (89/336/EEC)
and the low-voltage directive (73/23/EEC).
1 S-350
1 S-350 remote control
1 IEC connector (AC power) cord
2 AAA batteries
1 12 VDC (12 V trigger) cable
1 T-10 Torx wrench
1 Quick Setup Guide
Placement
AC POWER GUIDELINES
P/N 310784
v 1.0
Krell recommends using balanced
interconnect cables. Balanced
interconnect cables not only can minimize
sonic loss but are also immune to induced
noise, especially with installations using
long cables. Balanced connections have 6
dB more gain than single-ended
connections. When level matching is
critical, keep this gain value in mind.
Pin assignments for XLR connectors:
Pin 1 Shield (ground)
Pin 2 Non-inverting (hot) (0°)
Pin 3 Inverting (cold) (180°)
Note
The S-350 reads data discs. For example, if you
prepare a CDR or DVR containing MP3 audio files,
you can play the discs on the S-350. The following
terminology appears in the front panel display, to help
you navigate a data disc:
ROOT = The beginning of the disc.
F = A closed folder.
TOP = An open folder.
Press the enter button or key (11) to open a folder,
move to the previous folder, or play a track.
Press the up and down arrows or keys (10) to move
between tracks in a folder.
S-350
MODEL SERIAL NUMBER