Installing the flue grille, Leveling, Anti-tip device – La Cornue AlberTine 36 User Manual

Page 25: Floor fixing, Wall fixing

Advertising
background image

INSTALLATION

Check the appliance is electrically safe and gas sound when you have finished.

23

A

B

A

B

Installing the Flue Grille

The flue grille is packed separately (Fig.6-9).
The larger of the holes along the sides are for screwdriver

access and should face to the rear. Use the screws and nuts

supplied to hold the grille in place (Fig.6-10).
Clip the flexible extensions of the oven flues to the flue grille

using the clips provided inside the flue grille (Fig.6-11).

Leveling

It is recommended that you use a spirit level on a shelf in one

of the ovens to check for level.
Place the range in its intended position, taking care not to

twist it within the gap between the kitchen units as damage

may occur to the range or the units.
The front feet and rear rollers can be adjusted to level the

range. To adjust the height of the rear of the range turn the

adjusting nuts at the front bottom corners of the range. To set

the front, turn the feet bases to raise or lower.

Anti-Tip Device

WARNING: The range must be secured by the Anti-Tip

bracket supplied. Unless properly installed, the range

could be tipped by leaning on the door. Injury might

result from spilled hot liquids or from the range itself.
When fitting an anti-tip device please refer to the instructions

supplied with the device for further details on fitting.
Note: The range must be set to the correct height and leveled

before the anti-tip bracket is installed.

Floor Fixing

Using the screw supplied, assemble the anti-tip bracket base

and anti-tip bracket extension (Fig.6-12).
Using suitable screws and fixings, attach the assembled anti-

tip bracket to the floor to give a minimum engagement of

2½” (65 mm) into the back of the range.
Adjust and lock the inner anti-tip bracket to give a

1

/

8

” (3 mm)

clearance above the engagement edge in the back of the

range (Fig.6-13).

Wall Fixing

Where floor fixing is impractical and provided that the outer

anti-tip bracket can be attached to a solid wall, the anti-tip

device may be attached to a wall (Fig.6-14). Make sure to use

suitable screws and fixings.

ArtNo.280-0029 - Flue Grill

Fig.6-9

ArtNo.280-0030 - Fixing Flue Grill

ArtNo.280-0031 - Flue Extension Fixing

Fig.6-11

Fig.6-12

Fig.6-13

Fig.6-10

A – Outer anti-tip bracket, B – Inner anti-tip bracket

ArtNo.070-0014 - Stability bracket - Wall fitting

Cooker

Stability bracket

Floor

3 mm min

Anti-tip bracket

Range

1/8” (3mm) min

Fig.6-14

Cooker

Outer stability

bracket

Floor

Wall

3 mm min

Outer anti-tip

bracket

Range

1/8” (3mm) min

Advertising