La Cornue AlberTine 36 - Manual (Page 37)

INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
35
ArtNo.102-0005 - Gas regulator types
Type 1 Type 2
Fig.7-5
ArtNo.0102-0001 - Unscrewing
the control valve bypass screw
Replace the rings on the burners. Screw in the hexagon
headed venturi to make fitting the burners easier. Do not
tighten yet.
When all the burner bases and venturis have been fitted
tighten the venturi nuts.
Valve adjustment
Pull off all the control knobs.
Open both oven doors and remove the fixing screws
underneath the control panel.
On single oven models the cooling guide, below the control
panel, and its 4 fixing screws must be removed to gain access
to the control panel fixings.
Remove the 3 fixing screws at the top of the control panel.
Pull the control panel forward. Taking care not to damage it,
by protecting it with cloth for example, rest it on the open
oven doors.
To convert the control valves
Unscrew the control valve bypass screw (Fig.7-2). Using a
pair of long nose pliers, carefully remove the bypass screw
(Fig.7-3).
Install the correct replacement screw. See Table 7-2 for the
correct size. Tighten the screw down.
Valve bypass screws
Save the removed bypass screws for possible future
reconversion to Natural gas.
Reassemble
Replace the control panel and secure with fixing screws.
Refit the control panel and cooling guide where fitted.
If you have lifted the maintop, carefully lower it onto the
range. The burners are protected against the burner flames
going out by Flame Supervision Devices (FSD’s).
Take care when lowering the maintop to locate the FSD
sensor probes (Fig.7-4) in their holes in the cooktop and the
burner bases.
Gas Regulator
Pull the drawer right out.
Push the ends of the plastic clips – down of the left-hand side,
up on the right-hand side – to release the catches holding the
drawer to the side rails (Fig.7-5). At the same time pull the
drawer forwards and away from the side rails.
For safety’s sake push the drawer rails back out of the way.
The regulator is now accessible.
The regulator may be one of two types (Fig.7-6).
ArtNo.0102-0002 - Removing the
tap bypass screw
Fig.7-2
Natural Gas Propane Gas
Cooktop Bypass Bypass
Center burner 82 49
Large burners 70 38
Right front burner 53 31
Fig.7-3
Table 7-2
Fig.7-4
Fig.7-6