Powers PB410 Series Pressure Balancing Mixing Valves - Stem Extension Kit - Manual

USA: Phone: 1.800.669.5430 • Fax 1.847. 229.0526 • www.powerscontrols.com
Canada: Phone: 1.888.208.8927 • Fax 1.888.479.2887 • www.powerscontrols.ca
IS-P-410233-SE 1104 EDP# 6507675 © 2011 Powers
A Watts Water Technologies Company
Mixer Stem
Lever handle shown. Stem extensions may be "stacked" to
achieve a greater rough-in depth if needed.
Stem extension
3/4"
Lever handle Handle screw
STEM EXTENSION KIT #410-233 used on the following HydroGuards...Series 2000, Series P410 Models 1, 2, 3, and 5,
Series e420 Model 7-10, Series e420T/S, Series e700, Series F727 and Series PB410
The kit includes a stem extension and long screws to permit attachment of the stem extension. The long flat head screws
are also provided to attach the dial to the mixer bonnet. One kit adds 3/4” to the stem length.
The following table indicates where screws are used:
Installation Instructions
n
HYDROGUARD ® stem extension kit
for Series 2000, Series P410 Models 1, 2, 3, 5,
Series e420 Model 7-10, Series e420T/S, Series e700,
Series F727 and Series PB410
Technical Instructions
IS-P-410233-SE
Screws in Kit #410-233
Quantity Head Length Material Use to Attach...
2 flat 2-3/4 steel dials to mixer bonnet for e420, 2000 and P410
1 oval 1-1/2 chrome plated brass lever handle for e420, 2000 and P410
1 truss 1-1/4 steel lucite handle
2 oval 4 chrome plated brass dials to mixer bonnet for e700, F727 and PB410
1 oval 7/8 chrome plated brass lever handle for e420T/S, e700, F727 and PB410
1 oval 2 chrome plated brass stacking stem extensions
All screws have 8-32 threads