CatEye Q3 - Manual (Page 19)

ENG-18
Before use
Operation test
It may take up to approximately 2 minutes to display the screen because the *
wristwatch checks the sensor when switching to Sports mode.
If the signal icon * or on the measurement screen is turned off, press the
MODE1 or MODE2 button to turn it on.
Speed sensor (SPEED side)
1. Raise the rear wheel and spin the wheel.
2.
When the speed is displayed on the screen, it is oper-
ating normally.
Speed sensor (CADENCE side)
1. Turn the crank.
2.
When the cadence is displayed on the screen, it is
operating normally.
Heart rate sensor
1. Wear the heart rate sensor (page 12).
2.
When the heart rate is displayed on the screen, it is
operating normally.
* Heart rate sensor can also be activated by rubbing both electrode pads with
thumbs. This method cannot be used to measure the heart rate accurately,
but is used as a simple method for testing the sensor/wristwatch commu-
nication and searching for the sensor ID.
7
Electrode pad