CatEye Q3 - Manual (Page 26)

ENG-25
Sports mode
Continue
Lower display data
(Switch using the MODE2 button)
Displays additional ride data.
*1 The training function screen displays one of the following; countdown distance, countdown
time, or interval. For details, see “Training function (countdown function and interval
function)” on page 31.
*2 When measurement is stopped in the training function screen, shortcut operation (press
and hold the MODE2 button for 3 sec.) moves to the Setup mode “Setting the training
function” (page 35).
Starting/Stopping measurement
”km/h [mph]” icon flashes during speed measurement. Initially,
the auto-mode function which starts or stops measurement au-
tomatically in sync with the bicycle motion is ON. Auto measure-
ment is switched to manual measurement and vice versa by ON/
OFF operation in the auto-mode. For details, see the Setup mode
“Setting the auto-mode” (page 57). The maximum speed, maxi-
mum heart rate, and maximum cadence are updated regardless
of starting/stopping the measurement.
To use this unit as a heart rate monitor, start/stop the measure- *
ment using the SSS button in the manual measurement.
When the auto-mode is on, you cannot start the measurement.
Auto-mode (automatic measurement)
When the auto-mode is on, appears on the screen. The wristwatch detects the
wheel spinning, and starts/stops the measurement automatically.
When the transmission is stopped and Sensor signal icons * and are off, the
measurement will not start even after the bicycle starts. If a bicycle is stopped for more
than 5 minutes or if heart rate sensor is either far from the bicycle or off the body, it
will go into sleep. This normally happens when taking a rest during the ride. To re-
cover from the transmission sleep, press the MODE1 or MODE2 button to turn on the
sensor signal icons. For details, see “Transmission sleep mode” on page 22.
AT icon
Switch pressing the MODE2 button
Elapsed time
Clock
Trip distance
Calorie Consumption
Training function *1
Lap timer
MODE2
MODE2
MODE2
MODE2
MODE2
MODE2
MODE2
Shortcut *2
(press & hold for 3 sec)
To the setting count-down screen
in Option mode (page 35)
When the
measurement is
stopped