SoundOff Signal 100H Series Speaker - Manual

ETSS100H 3.08
The ETSS100H Siren Loudspeaker is used for high
powered transmission of electronic siren and voice
communications in vehicular applications.
SERIES 100H SPEAKER
ETSS100H
WARNING
!
Sirens produce loud sounds that
may damage hearing
Q Roll up windows
Q Wear hearing protection
Q Use only for emergency response
Q Avoid exposure to siren sound
outside of vehicle
MODEL POWER RATING IMPEDANCE FREQ. RESPONSE DISPERSION
ETSS100H 100 Watts RMS 11 Ohms Nominal 450-3500 Hz +/-10dB Nominal 80 o x 105 o 1KHz Octave Band
WARNING : Warning devices are strictly regulated and
governed by Federal, State and Municipal ordinances. These
devices shall be used ONLY on approved vehicles. It is the sole
responsibility of the user of these devices to ensure
compliance.
SAFETY MESSAGE TO OPERATORS AND
INSTALLERS OF SOUNDOFF SIGNAL
SIREN/SPEAKER SYSTEMS.
Signaling Limitations:
Sirens/speakers provide an essential function of an effective
audio-visual warning system. However, sirens are only short
range secondary devices. The use of a siren/speaker system
does not insure that all drivers can or will abide by or react to
an emergency warning signal, especially at high rates of
speeds or long distances. The operator of the vehicle must
never take the right of way for granted and it is the operator’s
responsibility to proceed safely.
The effectiveness of the siren/speaker system is highly
dependant on the correct mounting and wiring. The installer
must read and follow manufacturer’s installation instructions
and warnings in the manual. The vehicle operator should verify
the siren/speaker system is securely fastened to the vehicle
and properly functioning.
Maximum sound output will be severely reduced if any objects
are in front of the speaker. If your installation has obstructions
in front of the speaker, drive even more cautiously.
Sound Hazards:
Effective siren/speaker systems generate loud sound pressure
levels (120db) that can potentially cause permanent hearing
damage. Installers and those around the vehicle need to be
aware of the dangers and wear hearing protection whenever
the siren system is operating.
Vehicle operators and occupants should asses their exposure
to siren noise and determine what steps need to be taken to
prevent hearing damage. For hearing conservations guidance,
refer to federal, state, or local recommendations. OSHA
Standard 1910.95 offers guidance on Permissible Noise
Exposure”
The ETSS100H Siren Loudspeaker is used for high
powered transmission of electronic siren and voice
communications in vehicular applications.
Qualifications:
To properly install a siren, you must have a good
understanding of automotive systems, electronics and
procedures.
The siren/speaker system is intended for use by authorized
personnel only. The user’s responsibility to ensure they
understand and operate the emergency warning devices in
compliance with all applicable city, state, and federal laws
and regulations and have a thorough knowledge of state and
federal UNIFORM TRAFFIC CODES.
Soundoff Signal assumes no liability for any loss resulting in
the use of this warning device
During Installation:
Do not get metal shavings inside of speaker. Metal shavings can cause speaker to fail. If metal removing must be done near the speaker,
place a cover over the unit to prevent metal shavings from getting inside of speaker.
Do not route speaker wires where they may interfere with the operations or deployment of the air bag or it’s sensors. Equipment mounted
near the air bag deployment area will damage or reduce the effectiveness of the air bag. The user/installer assumes full responsibility to
determine proper mounting location, based on providing safety for passengers inside the vehicle.
After Installation:
Test the siren and light system to ensure that everything is operating properly.
Test all vehicle functions to ensure that installation has not affected vehicle operation or changed vehicle safety function.
Store these instructions in a safe place and refer to them when performing maintenance and/or reinstallation of product.
Note: The weep hole located in the front of the driver must be positioned at 6:00 o’clock when installed.
WARRANTY REPLACEMENT PARTS
SoundOff Signal warranties the ETSS100H Speaker for three (3)
years from the date of purchase to the original purchaser against
any manufacturing defects or workmanship. This warranty is a
100% replacement value warranty. It applies only to units installed
according to manufacturer’s installation instructions and operated
within the units specifications. Warranty is void if the unit was
installed incorrectly or maliciously damaged. All warranty claims
must be accompanied by a dated proof of purchase.
SoundOff Signal retains the right to be the sole mediator of what
constitutes defects in performance or manufacturing.