SoundOff Signal 200 Series Siren with Connectors User Manual
Warning
IMPORTANT INFORMATION:
Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances. These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these devices to ensure compliance.
To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at
www.soundoffsignal.com/sales-support.
If you have questions regarding this product, contact
Technical Services, Monday - Friday, 8 a.m. to 5 p.m. at 1.800338.7337 (press #4 to skip the automated message).
Questions or comments that do not require immediate attention may be emailed to
SUPERIOR CUSTOMER RELATIONSHIPS. SMARTLY DESIGNED LIGHTING & ELECTRONIC SOLUTIONS.
Effective sirens generate loud sound
pressure levels that can potentially
cause hearing damage. Installers and
those around the vehicle need to be
aware of the dangers and wear hearing
protection whenever the siren system
is operating. Vehicle operators and
occupants should assess their exposure
to siren noise and determine what steps
need to be taken to prevent hearing
damage.
The siren system is intended for use
by authorized personnel only. It is the
user’s responsibility to ensure they
understand and operate the emergency
warning devices in compliance with
all applicable city, state, and federal
laws and regulations. SoundOff
Signal assumes no liability for any
loss resulting from the use of the siren
system.
Package Contents:
1 ea. Amplifier
1 ea. Instruction Manual
1 ea. Operators Warning Card to
remain in vehicle for operator
review
1 ea. Sound Pressure Warning Label
that is to be attached in vehicle
and in plain site of operator and
occupants of the vehicle
1 ea. 3 Switch panel with:
1-ON/OFF/ON Switch
2-OFF/MOMENTARY Switch
1 ea. Electrical Isolation Hardware Kit
Wire capacity requirements for siren
amplifier (incoming power + ground)
0-10 Feet:
14 AWG
10-20 Feet: 12 AWG
20-30 Feet: 10 AWG
30+ Feet:
Consult Factory to
determine requirements
Please see reverse for
Technical Specifications
ETSA2ØØR(x) 6.13
Important Information:
• Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances.
These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these
devices to ensure compliance.
!
WARNING
Sirens produce loud sounds that
may damage hearing:
- Roll up windows.
- Wear hearing protection.
- Use only for emergency response.
- Avoid exposure to siren sound
outside of vehicle.
IMPORTANT NOTICE TO
INSTALLER:
Make sure to read and understand
all instructions and warnings before
proceeding with the installation of this
product. Ensure the manual and all
warning cards are delivered to the end
user of this equipment.
Introduction
The ETSA2ØØR(x) is a Compact Siren
Amplifier designed for single 100 Watt
speaker or dual 58 Watt use.
The primary operating modes are User
Selectable Tone, Yelp, Wail, Piercer,
Hi-Lo, Super Hi-Lo, Radio, PA, Horn
Override, and a Manual Override are
available in all modes.
Sirens provide an essential function
of an effective audio / visual warning
system. However, sirens are only short
range secondary devices. The use of
a siren does not insure that all drivers
can or will abide by or react to an
emergency warning signal, especially at
high rates of speeds or long distances.
The operator of the vehicle must never
take the right of way for granted and
it is the operator’s responsibility to
proceed safely.
The effectiveness of this siren system
is highly dependant on the correct
mounting and wiring. The installer must
read and follow the manufacturer’s
installation instructions and warnings in
the manual. The vehicle operator should
verify the siren system is securely
fastened to the vehicle and properly
functioning.
ETSA2ØØRW - W/ WEATHER PAK CONNECTOR
ETSA2ØØRA - W/ AMP CONNECTOR
CONNECTORS AND HARNESSES
INCLUDED IN WEATHER-PAK
SIREN.
HARNESS INCLUDED IN AMP
CONNECTOR SIREN. FEMALE
CONNECTOR NOT SHOWN.