Trail Master Suspension TM407N FORD F-150 4WD 6 SUSPENSION LIFT KIT - Manual

WARNING
Many states and municipalities have laws restricting
bumper heights and vehicle lifts. Consult state and local
laws to determine if the changes you intend to make to
the vehicle comply with the law.
WARNING
The installation of larger tires may reduce the effective-
ness of the braking system.
WARNING
Always wear eye protection when operating power tools.
WARNING
Before you install this kit, block the vehicle tires to pre-
vent the vehicle from rolling.
WARNING
DO NOT combine suspension, body, or other lift devices.
Use of vehicle with combined lifts may result in unsafe
and/or unexpected handling characteristics.
NOTE
Lift height may vary depending on vehicle configuration,
engine size, additional accessories, the factory suspen-
sion package, and vehicle’s condition.
NOTE
Trail Master recommends using thread locking com-
pound on the threads of all kit nuts and bolts unless
specified otherwise in these instructions.
400 W. Artesia Blvd. Fax: (310) 747-3912
Compton, CA 90220 Ph: (877) 695-7812
www.trailmastersuspension.com
FORD F-150 4WD 6” SUSPENSION LIFT KIT
2004– 2008 KIT# TM407N
WARNING
Installation of a Trail Master suspension lift kit will
change the vehicle’s center of gravity and handling char-
acteristics both on- and off-road. You must drive the ve-
hicle safely! Extreme care must be taken to prevent vehi-
cle rollover or loss of control, which could result in seri-
ous injury or death. Avoid sudden sharp turns or abrupt
maneuvers and always make sure all vehicle occupants
have their seat belts fastened.
WARNING
Before you install this kit, read and understand all in-
structions, warnings, cautions, and notes in this instruc-
tion sheet and in the vehicle owner’s manual.
CAUTION
Proper installation of this kit requires knowledge of the
factory recommended procedures for removal and instal-
lation of original equipment components. We recommend
that the factory shop manual and any special tools
needed to service your vehicle be on hand during the
installation. Installation of this kit without proper knowl-
edge of the factory recommended procedures may affect
the performance of these components and the safety of
the vehicle. We strongly recommend that a certified me-
chanic familiar with the installation of similar components
install this kit.
WARNING
This kit should only be installed on a vehicle that is in
good working condition. Before you install the kit, thor-
oughly inspect the vehicle for corrosion or deformation of
the sheet metal. If the vehicle is suspected to have been
in a collision or misused, do not install this kit. Off-road
use of your vehicle with this kit installed may increase
the stress applied to the factory components. Failure to
observe this warning may result in serious personal in-
jury and/or severe damage to your vehicle.