Craftsman 0220 - Manual (Page 45)


Inspection and Service each 6 Months or 6,000 Miles
Suspension Inspect for bending loose fas-
teners, wear
Section 10.2.10
Inspection and Service each year or 12,000 Miles
Item Inspection/Service Manual Section Reference
Structure
• Frame members
• Welds
• Slide-out
Inspect all frame members, bolts
& rivets. Repair or replace dam-
aged, worn or broken parts.
Inspect all welds. Repair as
needed
Clean dirt build-up. Lubricate
slides, shafts and gears
Section 10.2.2
Section 10.2.2.1
Section 10.2.2.2
Structure
• Axle Attachment Bolts
Check WITH DEALER Section 10.2.1
10.2 Inspection and Service Instructions
10.2.1 Axle bolts, Frame, Suspension, & Structure
To perform many of the inspection and maintenance activities, you must jack up the
trailer.
When jacking and using jack stands, place them so as to clear wiring and suspension
parts (springs, torsion bars, etc.). Place jacks and jack stands inside of the perimeter
strip on the supporting structure to which the axles are attached.
WARNING
Worn or broken suspension parts can cause loss of control and
property damage, serious injury and death may result. Have
trailer professionally inspected annually and after any impact.
WARNING
Never crawl under your trailer unless it is on firm and level ground
and resting on properly placed and secured jack stands.
Never attempt to change the tire while trailer is in folded
position. Trailer can tip over.
Failure to heed these warnings could result in property damage,
serious injury and death.
WARNING
Do not use the Assist Wheel to support the Trailer while
changing your tires. Trailer could tip over causing serious injury
or death.