CCI Thermal Technologies AC-SN, AC-GR - Protection Grills - Manual

The protection grill provided by CCI Thermal as an optional accessory for the Cata-Dyne™ heater
has been redesigned to allow for easy installation and/or removal. The 12" x 24" grill(s) are fastened
to the bezel assembly. The bezel assembly is the rectangular steel frame riveted around the front of
the Cata-Dyne™ heater. No assembly hardware or tools are required to attach the grill(s).
•
To remove the protection grill, perform the above steps in reverse order.
• Exercise care not to damage the heater's catalyst pad when installing or removing the protection grill.
Caution! Do not Attempt to Install or Remove the Protection Grill While the Heater is in Operation.
How to Install the
Cata-Dyne™ Protection Grill
CCI Thermal Technologies Inc.
Head Office & Factory
5918 Roper Road, Edmonton, Alberta, Canada T6B 3E1
Toll Free: 1-800-661-8529
www.ccithermal.com [email protected]
M20512-010
Step #1
Insert the installation hooks
on the 12” side of the
protection grill into the holes
provided on the heater’s bezel
assembly
Step #2
Pull the protection grill over
the bezel assembly and snap
the installation hooks into the
holes provided
Installation Holes
(on bezel
assembly)
Installation Hooks
(on protection grill)
December 2007