CCI Thermal Technologies XB - Explosion-Proof Natural Convection Heater (Optional Adjustable Temperature Control) - Manual

1.0 SPECIAL NOTICES
1.1 The following special notices highlight
important information in the installation and
maintenance sections. Each serves a special
purpose and is displayed in the format shown:
This symbol indicates a potentially hazardous
situation, which, if not avoided, can result in
personal injury or damage to the equipment.
This symbol indicates a potentially hazardous
situation, which, if not avoided, may be a
shock hazard.
This symbol indicates an imminently hazardous
situation, which, if not avoided, could result in
death or serious injury.
2.0 PRE-INSTALLATION
2.1 Initially, inspect the heater for possible
damage due to shipping and handling. Claims
for shipping damages shall be placed with the
carrier.
2.2 Check the heater nameplate to ensure that
the heater area classification and temperature
code are suitable for the hazardous area
classification. For details of hazardous
locations with potential for explosion, refer
to the Canadian Electrical Code or National
Electrical Code.
2.3 Check to ensure that the heater voltage is the
same as the supply voltage.
2.4 The heater must be installed by qualified
personnel in strict compliance with national
and local electrical codes.
WARNING
DO NOT CONNECT THE HEATER TO AN
ELECTRICAL SUPPLY VOLTAGE OTHER
THAN THAT SHOWN ON THE PRODUCT
NAMEPLATE.
3.0 INSTALLATION - GENERAL REQUIREMENTS
3.1 Norseman TM XB heaters are approved for wall
or floor mounting with the terminal housing at
the bottom. Ensure that is the wall sufficiently
strong to support the heater which, depending
on the model, could weigh up to 100 lbs (45
kg). Otherwise use the brackets supplied to
stand the heater on the floor.
3.2 Do not recess the Norseman TM XB heater
into the wall. Use of the brackets supplied will
ensure that the minimum spacing from the
wall of 3.75” (95 mm) is maintained.
3.3 If more than one heater is being installed,
maintain at least 3” (76 mm) between adjacent
heater extrusions. NEVER INSTALL ONE
HEATER ABOVE THE OTHER.
3.4 The Norseman TM XB heater relies on natural
convection and “black heat” radiation to transfer
heat to the surroundings. Try to maintain a 12”
(300 mm) clearance and NEVER LESS THAN
6” (150 mm) clearance in front of and at the
sides of the heater.
3.5 Use guard rails in front of the heater if there
is a possibility that moving equipment could
come in contact with the heater.
TYPE XB EXPLOSION-PROOF
CONVECTION PANEL HEATER
INSTALLATION, OPERATION &
MAINTENANCE INSTRUCTIONS
E-mail: [email protected] www.ccithermal.com
Date of Issue: November 2013
10457.Rev.2.01
Printed In Canada
C US
®
CAUTION
CAUTION
WARNING
POCC CA. ГБ06.B00913 ISO 9001