CCI Thermal Technologies G Series - Industrial Infrared Gas Catalytic Heater - Manual

1.0 SPECIAL NOTICES
1.1 The following special notices highlight
important information in the installation and
maintenance sections. Each serves a special
purpose and is displayed in the format shown:
This symbol indicates a potentially hazardous
situation, which, if not avoided, can result in
personal injury or damage to the equipment.
This symbol indicates a potentially hazardous
situation, which, if not avoided, may be a
shock hazard.
This symbol indicates an imminently
hazardous situation, which, if not avoided,
could result in death or serious injury.
WARNING
WARNING: IMPROPER INSTALLATION,
ADJUSTMENT, ALTERATION, EXCESSIVE
VIBRATION, SERVICE OR MAINTENANCE
CAN CAUSE PROPERTY DAMAGE, INJURY
OR DEATH. READ THE INSTALLATION,
OPERATING AND MAINTENANCE
INSTRUCTIONS THOROUGHLY BEFORE
INSTALLATION OR SERVICING THIS
EQUIPMENT.
2.0 CERTIFICATION
2.1 Model BX (Series X), Model WX (Series X) &
MKII Cata-Dyne™ explosion-proof, flameless
infrared catalytic gas heaters are certified by
the Canadian Standards Association (CSA)
for use in Class I, Divisions 1 and 2, Group
D hazardous (classified) locations and FM
Approvals, for use in Class I, Division 1,
Group D hazardous (classified) locations,
temperature code T2C at an ambient
temperature of 104ºF (40ºC).
2.2 Model WXS (Series X) is FM certified for Class
I, Division I, Group D, temperature code T2B
at an ambient temperature of 104°F (40°C).
STANDARD HEATER APPLICATIONS
INSTALLATION & OPERATION INSTRUCTIONS
E-mail: [email protected] www.ccithermal.com
Date of Issue: January 2013
M20724-008.Rev.4.03
Printed In Canada
CAUTION
CAUTION
WARNING
2.3 Models WX & MKII are certified ATEX/CE
for use in gas environments, Category 2,
Zone 1 & 2, Group IIA.
2.4 The Model BX (Series G) Cata-Dyne™
heater is certified by CSA and FM for use in
general industrial non-hazardous locations.
Models listed are certified for industrial use
only, for either natural gas or propane gas.
CSA approved models are equipped for high
altitudes: 0 to 4500 ft (0 m to 1370 m) above
sea level.
3.0 INTENDED USE
3.1 The Cata-Dyne™ heater can be used in all
industrial indoor locations where a source
of infrared radiant heat is required, where
adequate ventilation is available.
4.0 INSTALLATION
4.1 To ensure maximum efficiency of your
Cata-Dyne™ heater, it should be installed
with the heating surface positioned plus or
minus 45° from the vertical plane at a height
of no more than 8 ft (2.44 m). All heaters
must be installed in accordance with the latest
revisions of the codes described in TABLE 1
and in accordance with any local codes and
regulations. Before installing the heater, all
information on the heater nameplate must
be carefully reviewed. The nameplate lists
all the fuel and electrical requirements for
the heater.
TABLE 1 - NATIONAL CODE REQUIREMENTS
All Cata-Dyne™ Heaters Installed:
In Canada In The USA Internationally
CSA/CAN-C22.1-02
Canadian Electrical Code
CSA/CAN-B149.1-00,
Natural Gas and Propane
Installation Code
NFPA 70, National
Electrical Code
NFPA 54, National
Fuel Gas Code
Install according to
local and national/
international fuel and
electrical codes
C US
®
POCC CA. HO02 H01561 ISO 9001
BKI
Ж
1418