Compatible Systems MicroRouter 1270i - Manual (Page 29)

Chapter 6 - Basic Configuration Guide 23
information than dedicated line setup. Outgoing dial-on-demand
requires additional information (see the suggested settings below).
• Set dial-up connection
• Set PPP connection
• Set to allow dial-in and/or dial-out
CV: Use the Link Configuration: WAN 1.
TB: Use configure and set the Mode, ConnectMode, DialIn and/or
DialOut keywords in the Link Config WAN 1 section.
Suggested for Dial-On-Demand Operation
This mode of operation is only supported on the WAN 1 RS-232 inter-
face. Outgoing dial-on-demand requires some additional information.
• Create dial-out script
• Set dialing method
• Set dial-out script to be used
• Set inactivity time
CV: Use the Link Configuration: WAN 1 Dialog Box to set the dialing
method and to select a chat script (once you have created one).
Use the WAN Chat Scripts Dialog Box (under Global/WAN Chat
Scripts) to create your chat script.
TB: Use configure and then set the Dialing, DialOutScript, and
DropInact keywords in the Link Config WAN 1 section. Use
edit config and create a Chat section to contain your dialing
script.
IP Protocol
Required for IP
WAN interfaces which are set for PPP operation do not generally use an
IP address. They are set to act as an “unnumbered interface.” In this
mode of operation, there are no required settings.
Suggested for IP
These parameters help supply information about the segment that the
interface is connected to. With this information, routing can take place.
• Set IP RIP 1, IP RIP 2, or OSPF (Open Shortest Path First)
• Set IP static routes
CV: Use the TCP/IP Routing: WAN Dialog Box to set RIP, and the IP