SARGENT AL - Alarmed Exit - Manual (Page 2)

2
1. Mount exit device per instruction sheet provided.
2. TL- (SARGuide) only without other rail wiring requirements - Install 4 to 8-pin patch cable between the rail and
raceway connectors.
TL- (SARGuide) with other rail wiring requirements - Do NOT install 4 to 8-pin patch cable.
Refer to the wiring diagrams on the following pages.
If additional electrical functions exist, plug rail 8 & 4-pin connectors into raceway connectors. Feed harnesses
through 1" hole in door. Install rail mounting bracket with two screws supplied. Install rail insert and end cap.
To insure trouble free operation, check that the push rail can be fully depressed.
On vertical rod exit devices, adjust rods and check that the latch bolts do not go into hold back position until the
push rail is fully depressed.
3. Plug raceway connector(s) into electric hinge connector(s), then feed through door prep. Mount electric hinge to door.
4. Go to (A) if wiring now. Go to (B) if wiring is to be done later.
A. Refer to wiring examples. Wire loose frame side wires to loose wires on pigtail harness as required, using
connectors allowed by local code. Plug pigtail harness connector(s) into electric hinge connector(s). Feed
harnesses through frame prep and mount electric hinge. Apply power and test exit device
B. Plug pigtail harness connector(s) into electric hinge connector(s). Feed harnesses through frame prep and
mount electric hinge.
E. TL- SARGuide Exit Device Installation
Pigtail harness
assembly with
8-pin connector
Electric Hinge with
8-pin connector
Raceway harness with
8 & 4-pin connectors.
The 4-pin connectors
are not used here.
4
EXIT EXIT EX
IT
2
1
TL- SARGuide
80 Series Rail
with 4-pin connector
EXIT EXIT EX
IT
4 to 8-pin
patch cable
(see note 2)
1" dia
hole
in door
Mounting
bracket
Screw
location
3
Copyright © 2009, SARGENT Manufacturing. All rights reserved.
Reproduction in whole or in part without the express written
permission of SARGENT Manufacturing is prohibited.
A7711C - 5-1-9