Monarch Instrument ROLS24-W - Manual

ROLS24-W
Remote Optical Laser Sensor
SAFEGUARDS AND PRECAUTIONS:
WARNING – Class 2 laser product – This product emits a visible beam of
laser light. Avoid exposure to the laser radiation. The use of optical viewing
aids (binoculars, for example) may increase the ocular hazard.
CAUTION – The laser beam should not be intentionally aimed at people or
animals.
CAUTION – Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation exposure.
Read and follow all instructions in this instruction sheet carefully, and retain this sheet for future reference.
Do not use this instrument in any manner inconsistent with these operating instructions or under any
conditions that exceed the environmental specifications stated.
This instrument is not user serviceable. For technical assistance, contact the sales organization from which you
purchased the product.
DESCRIPTION:
The Remote Optical Laser Sensor has a visible red laser light source and green
LED on-target indicator. The class 2 laser source acts as the aiming device during
setup and can accurately measure speeds from 1-250,000 RPM from a distance of
up to 25 feet with a maximum offset angle of 60 degrees from the rotating object.
The sensor is housed in a threaded 303 stainless steel tube and supplied with a 90
degree mounting bracket, jam nuts and an eight foot shielded cable. ROLS24-W
comes with 4 tinned wires.
SPECIFICATIONS:
Speed Range: 1-250,000 RPM
Illumination: Visible Red Laser, Class 2
Laser Specifications: Classification: Class 2 (per IEC 60825-1 Ed 1.2 2001-8)
Complies with FDA performance standards for laser products except for deviations pursuant to Laser
Notice No. 50, dated July 26, 2001.
Maximum Laser Output: 1mW
Pulse Duration:
Continuous
Laser Wavelength: 650 nm
Beam Divergence: <1.5 mrad
Beam Diameter: 4 x 7 mm typical at 2 meters
Laser Diode Life: 8,000 operating hours MTBF (1 year warranty)
On-Target Indicator: Green LED on wire end cap
Operating Range:
up to 25 feet [7.6 m] and 60 degrees offset from target
Power Requirement: 9 - 24 Vdc, 0.13W
Output: Positive pulse when target present – Output Voltage=Supply Voltage
Optional – Open Collector or TTL pulse, Negative pulse (Contact factory)
Operating Temp.: 14 °F to 158° F [-10 °C to 70° C]
Humidity: Maximum relative humidity 80% for temperature up to 88 °F [31 °C] decreasing linearly to 50%
relative humidity at 104 °F [40 °C]
Connection: Tinned wires
Cable Length: 8 feet [2.4 m]
Material: 303 Stainless Steel supplied with two M18 Jam Nuts and Mounting Bracket
Lens: Acrylic Plastic
Dimensions: Threaded Tube 3.12 in x 0.71 in diameter [M18 x 1.5 x 79.4 mm] long
LASER RADIATION
AVOID DIRECT EYE EXPOSURE
CLASS 2 LASER PRODUCT
MAX OUTPUT POWER: 1mW
EMITTED WAVELENGTH: 650nm
CLASSIFIED TO IEC 60825-1:2001
WARNING:
Laser light
emitted from
this aperture