Monarch Instrument Track-It RFID Quick Start User Manual
Configure your data logger
Download and install the Track-It™ RFID application from Google Play. Scan the
QR code below with your Android device. Or navigate to the address below. This
will bring you directly to the App on Google Play.
1
Install Android Application on Compatible Device*
*The Track-It™ RFID application will only work on compatible Android
devices with Near Field Communication (NFC). A current list of compatible
devices can be found at:
http://en.wikipedia.org/wiki/List_of_NFC-enabled_mobile_devices
2
Open RFID Application on your Android device
Once the RFID logger application has been downloaded and installed to your
device find the RFID Logger icon and start the program. Ensure NFC (Near Field
Communication) on this device is turned “On”. Place and hold the RFID logger
directly against your device and in the location of your devices NFC antenna
(typically on the back of the device. Refer to your manual for exact location). Hold
in place until the application indicates it has finished reading. It takes
approximately 2-3 seconds to retrieve
and open the summary page.
Always ensure logger antenna is in the
NFC area of Phone/Tablet
Google Nexus 7 2nd generation shown.
3
View Summary Information
The Summary page shows details including unit tag name, serial number, battery
voltage and current record status. It also shows the number of samples and start
and end time of the record. Alarms that have occurred during the record session
will also be indicated on this page.
Touching the data tab will initiate a
full data download. Place Logger in
NFC antenna location and hold in
place. Full data transfer can take up
to 8 seconds.
Touching graph tab will open the
graphic trend page. If data has
already been transferred this
happens instantly otherwise use
same method to transfer data.
Touch the “Tools” icon to enter the
configuration mode. You can then set
the parameters for recording data.
4
Configure your data logger
The configuration menu allows you to assign a Tag Name and set the logger to
record now, on button press or after a time delay. You can also set the record
rate and up to 4 alarm set points.
Record rate tab
Alarm setup tab
Once you have finalized all of your
settings you can send the
configuration to the data logger.
1.
Make sure the Enable box is
checked.
2.
Touch the send to logger icon.
3.
Place the logger against your
device and wait for
confirmation that your
configuration has successfully
transferred. You are now
ready to deploy your data
logger!