Wheatheart X160 Series User Manual
Grain augers
Advertising
Table of contents
Document Outline
- 1. Introduction
- 2. Safety
- 3. Assembly
- 3.1. General Assembly
- 3.2. Assemble the Auger Tube
- 3.2.1. Identify and Arrange Auger Tube Sections
- 3.2.2. Connect Auger Tubes
- 3.2.3. Install the Hydraulic Lift Cylinders
- 3.2.4. Install the Track Shoe and Track Stop
- 3.2.5. Install the Boot on the Auger Tube
- 3.2.6. Assemble the PTO Shield Assembly
- 3.2.7. Install the Speed Reducer on the Boot
- 3.2.8. Install the Boot Tow Bar
- 3.2.9. Install the Discharge Spout
- 3.2.10. Set the Thrust Adjuster
- 3.2.11. Apply Logo and Model Decals on the Auger Tubes
- 3.3. Install Truss Support Towers and Truss Tubes
- 3.4. Install Truss Cables
- 3.5. Assemble the Lower Frame
- 3.6. Assemble the Wheel Hub and Install Tires
- 3.7. Connect the Auger Tube to the Frame
- 3.8. Install Lift Cylinder Cables to the Track shoe
- 3.9. Connect Hydraulic Hoses and Ball Valve
- 3.10. Connect the PTO Driveline
- 3.11. Connect the Intake Hopper to the Swing Tube
- 3.12. Connect the Spout Head to the Grain Transfer Boot
- 3.13. Install the Hopper Lift Arm
- 3.14. Install the Hydraulic Winch
- 3.15. Power Swing Assembly
- 3.16. Install the Hitch Jack
- 3.17. Install the Manual Container
- 3.18. Auger-to-Tractor Hookup
- 4. Transport
- 5. Placement
- 6. Operation
- 7. Maintenance and Storage
- 7.1. Maintenance Intervals
- 7.2. Fluids and Lubricants
- 7.3. Maintenance Procedures
- 7.3.1. Visual Inspection
- 7.3.2. Hydraulic Hose and Coupler Inspection
- 7.3.3. Machine Greasing
- 7.3.4. Hopper Lift Cable Inspection
- 7.3.5. Winch and Pulley Servicing
- 7.3.6. Gearbox Coupling Shaft Servicing
- 7.3.7. Hopper Chain Drive Servicing
- 7.3.8. Gearbox Oil Level
- 7.3.9. Machine Cleaning
- 7.3.10. Tire Pressure Check
- 7.3.11. Wheel Bearings Repack
- 7.3.12. Wheel Bolt Tightening
- 7.3.13. Truss Cable Adjustment
- 7.3.14. Changing Gearbox Oil
- 7.4. Storage
- 7.5. Power Swing
- 8. Troubleshooting
- 9. Appendix