Canon LV-X2 - Manual (Page 41)

41
APPENDIX
WARNING :
High voltages are used to operate this projector. Do not attempt to open the cabinet.
If the problem still persists after following all operating instructions, contact the sales dealer where you purchased the
projector or the service center. Give the model number and explain the problem in detail. We will advise you of how to
obtain service.
Remote Control Unit
does not work.
● Check the battery.
● Make sure nothing is between the Infrared Remote Receiver and the Remote Control
Unit.
● Observe maximum operating distance 16.4’ (5m) between the receiver on the projector
and the Remote Control Unit.
● Make sure the code of the Remote Control Unit is set to conform to the projector.
(See “SETTING” section on page 35, 36.)
Problem: Try these Solutions
This symbol on the nameplate means the product is Listed by Underwriters
Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety standards
against risk of fire, casualty and electrical hazards.
The CE Mark is a Directive conformity mark of the European Community. (EC)