Canon BJC-620 - Manual (Page 83)

&RPSDT    %,26
•
Go to Device manager
•
Click on the + Sign By Ports
•
Double-click on the ECP Printer Port
•
Select Resource Tab, and Make a Note of the Resources Settings
•
Cancel Out of the LPT Port Properties
•
Remove the ECP Printer Port From Device Manager
•
Restart the Computer and Press the FIO Key (at 2 beeps or any other appropriate
prompt)
•
Press Enter, and Enter Again to Acknowledge Openings Messages
•
Select Setup
•
Select Communications
•
Go to the LPT Port and Select the Resource Group that Matches the one Noted in
Device Manager (setup 4) ***but without the dma***
•
Exit and Save, the System will reboot, and should detect and configure a "NON
ECP" Printer Port including the Printer
&203$4 3UHVDULR &'6 
•
While Rebooting, Hit FlO to Enter Setup
•
Click on Communications Section
•
Click on LPT PORT MODE
•
Select Bi-directional
•
Click (or Hit) Exit
•
When it asks you if you want to save, Hit "Y" for Yes
'HOO 'LPHQVLRQ 3
•
Press Delete to Enter Setup
•
Press Delete to Enter Setup
•
Press ALT P
•
Cursor to Parallel Mode
•
Change to PS/2 or ECP by Using Arrow Keys
•
Pressing Escape will Exit and Save Changes
 7URXEOHVKRRWLQJ
Chapter 5