Antennacraft 10Y203 - Manual

Thank you for purchasing your heavy-
duty 3-foot antenna mast tripod from
Antennacraft. Your tripod makes it easy
to install an outdoor antenna on your
roof.
What’s Included
Tripod
5 /
16
Inch Bolts (6)
L-Bracket
Pitch Pads (3)
Foot Brackets (3, two are attached)
¼ Inch Bolt
Lockwasher
Lag Bolts (6)
Square Nuts (6)
Hex Nuts (7)
User’s Guide
Limited Warranty
This product is warranted by
Antennacraft against manufacturing
defects in material and workmanship
under normal use for ninety (90)
days from the date of purchase from
Antennacraft dealers. For complete
warranty details and exclusions, check
with your local Antennacraft dealer.
Antennacraft Customer Relations
PO Box 1005, Burlington, IA 52601
05/09 www.antennacraft.net
7010Y203IS 1500293
Lag Bolts +
Pitch Pads
Installing Your Tripod
1. Position the tripod as desired,
and attach a pitch pad under each
foot. Then, tighten the hex nut on the
bolted foot.
2. Attach the tripod to your roof
using two lag bolts to secure each
foot.
3.
The tripod accepts antenna
masts up to 1½" (38 mm). Run the
mast (not supplied) through the
upper and lower brackets, resting on
the L-bracket. If you cannot run the
mast through the brackets, adjust
the bolts.
4. Tighten the hex nuts and square
nuts to lock the mast in position.
Assembling Your Tripod
1. Unfold the tripod legs. Make sure the
foot brackets sit flat on the ground.
3. Insert the bolts with the hex nuts
through the three holes on the tripod
upper bracket and the three holes on
the tripod lower bracket. Attach the L-
bracket to the lower bracket with one
of the bolts.
4. Thread a square nut onto the end of
each bolt.
5. Insert the 1/4-inch bolt through the
supplied, unattached foot bracket
and the tripod’s front leg. Thread the
lockwasher and a hex nut onto the
bolt.
Mast
Upper
Bracket
Front Leg
Lower
Bracket
Attached
Foot
Brackets Front Leg
Lag Bolt
1 /
4
-Inch
Bolt
Pitch Pad
Hex Nut
Lockwasher
Foot Bracket
5 /
16
-Inch Bolt
Hex Nut
Square Nut
L-Bracket
Mast
Note: For easy access to the antenna
after installation, you can remove the
foot bracket from the front leg to tilt
the tripod.
3 Foot (.91 m) Heavy-Duty
Antenna Mast Tripod
2. Thread a hex nut onto each 5/16-
inch bolt (six total).