Yealink SIP-T22 User Manual

Enterprise ip phone, Sip-t22p & sip-t22, Quick installation guide

Advertising
background image

Accessing the web user interface:

Account Settings: Click on Account->Register->Account X (X=1,2,3)

Parameters of the account:

Network Settings:

Account Settings:

Configuring via phone user interface

Configuring via web user interface

Configuring Your Phone

Register status icons on the LCD screen:

SIP-T22P & SIP-T22

Enterprise IP Phone

Quick Installation Guide

www.yealink.com

Note: Please locate your computer in the same network segment of the IP phone (192.168.0.X) to access the

web user interface. Contact your system administrator for more information.

Note: Check with your system administrator if any error appears during the registration process or a specific

configuration is required for your registration.

Note: The wrong network settings may result in inaccessibility of your phone and may have an impact on the

network performance. Contact your system administrator for more information.

1. Press the OK key when the phone is idle to get the IP address of the phone.

You can configure the network in the following ways:

It shows the register status of the current account.

You can select Enabled/Disabled to enable/disable the account.

It is shown on the LCD to identify the account.

It is shown as caller ID when placing a call.
It is provided by ITSP for registration (required).

It is an authenticated ID for authentication provided by ITSP (required).

It is provided by ITSP for registration (required).
It is provided by ITSP for registration (required).

DHCP: By default, the phone attempts to contact a DHCP server in your network to obtain its valid

network settings, e.g., IP address, subnet mask, gateway address and DNS address.

Static IP Address: If your phone cannot contact a DHCP server for any reason, you need to

configure IP address, subnet mask, gateway address, primary DNS address and

secondary DNS address for the phone manually.
PPPoE: If you are using an xDSL modem, you can connect your phone to the Internet via PPPoE

mode. Contact the ITSP for the PPPoE user name and password.

Press the Menu soft key when the phone is idle, select Settings->Advanced Settings (password:admin)

->Network->WAN Port/PC Port/VLAN/Webserver Type/802.1x Settings/VPN to configure the network.

For more information, refer to the User Guide available online:

http://www.yealink.com/SupportDownloadfiles_detail.aspx?CateId=186&flag=142

Copyright 2014 YEALINK NETWORK TECHNOLOGY CO.,LTD.

Press the Menu soft key when the phone is idle, select Settings->Advanced Settings (password:admin)

->Accounts to configure the account.

2. Open the web browser on your computer, enter the IP address into the address bar (e.g.,

"http://192.168.0.10" or "192.168.0.10") and press Enter.

Register Status:

Line Active:

Label:

Display Name:

User Name:

Register Name:

Password:

Server Host:

3. Enter the user name (default: admin) and password (default: admin) in the login page

and click Confirm.

Network Settings: Click on Network->Basic->IPv4 Config

Note: For more information on account parameters, refer to Configuring via web user interface.

Registered

Register Failed

Registering

c

Applies to firmware version 72.1 or later.

Applies to firmware version 72.25 or later.

Applies to firmware version 72.1 or later.

Advertising
This manual is related to the following products:
Table of contents