Yealink SIP-T42G User Manual

Ultra-elegant gigabit ip phone, Sip-t42g, Quick installation guide

Advertising
background image

Accessing the web user interface:

Account Settings: Click on Account->Register->Account X (X=1,2,3)

Parameters of the account:

Network Settings:

Account Settings:

Configuring via phone user interface

Configuring via web user interface

Configuring Your Phone

Register status icons on the LCD screen:

Quick Installation Guide

www.yealink.com

Note: Check with your system administrator if any error appears during the registration process or a specific

configuration is required for your registration.

Note: The wrong network settings may result in the inaccessibility of your phone and may have an impact on the

network performance. Contact your system administrator for more information.

1. Press the OK key when the phone is idle to obtain the IP address of the phone.

You can configure the network settings in the following ways:

It shows the register status of the current account.

You can select Enabled/Disabled to enable/disable the account.

It is shown on the LCD to identify the account.

It is shown as Caller ID when placing a call.
It is an authenticated ID for authentication provided by ITSP (required).

It is provided by ITSP for registration (required).

It is provided by ITSP for registration (required).
It is provided by ITSP for registration (required).

DHCP: By default, the phone attempts to contact a DHCP server in your network to obtain its valid

network settings, e.g., IP address, subnet mask, gateway address and DNS address.
Static IP Address: If your phone can not contact a DHCP server for any reason, you need to

configure the IP address, subnet mask, gateway address, primary DNS address and

secondary DNS address for the phone manually.

Press the Menu soft key when the phone is idle, select Settings->Advanced Settings (password: admin)

->Network->WAN Port/VLAN/Webserver Type/802.1x Settings/VPN to configure the network.

For more information, refer to the User Guide available online:

http://www.yealink.com/SupportDownloadfiles_detail.aspx?CateId=312&flag=142

Press the Menu soft key when the phone is idle, select Settings->Advanced Settings (password: admin)

->Accounts to configure the account.

2. Open the web browser on your computer, enter the IP address into the address bar (e.g.,

"http://192.168.0.10" or "192.168.0.10"), and then press the Enter key.

Register Status:

Line Active:

Label:

Display Name:

Register Name:

User Name:

Password:

Server Host:

3. Enter the user name (default: admin) and password (default: admin) in the login page

and click Confirm.

Network Settings: Click on Network->Basic->IPv4 Config

Registered

Register Failed

Registering

Copyright 2014 YEALINK NETWORK TECHNOLOGY CO.,LTD.

c

SIP-T42G

Ultra-elegant Gigabit IP Phone

Applies to firmware version 72.1 or later.

Note:

For more informantion on account parameters, refer to Configuring via web user interface

.

(V72.4)

Advertising
Table of contents