Yamaha LS9 - Manual (Page 119)

119
Using dynamics
11
EQ and Dynamics
LS9-16/32 Owner’s Manual
6
Select the key-in signal as necessary.
You can select one of the following as the key-in sig-
nal.
*1: The signals that you can select are limited to the group to which
that channel belongs, from the following five {nine} groups: CH
1–8, CH 9–16, CH17–24, CH25–32, {CH33–40, CH41–48,
CH49–56, CH57–64}, and STIN1L1R–4L4R.
*1: The signals that you can select are limited to the group to which
that channel belongs, from the following four groups: MIX 1–8,
MIX 9–16, MATRIX 1–8, and ST/MONO.
To select the key-in signal, make your selection in the
DYNAMICS 1/DYNAMICS 2 popup window.
1 Move the cursor to the KEY IN SOURCE box,
and use the dial or the [DEC]/[INC] keys to
select the desired key-in signal.
The newly selected key-in signal will blink.
B Press the [ENTER] key to confirm your selec-
tion of key-in signal.
7
If you want to initialize dynamics settings or
copy them to another channel, use the tool
buttons in the DYNAMICS 1/DYNAMICS 2
popup window.
For details on how to use these buttons, refer to “Using
the tool buttons” (
→ p. 35).
For an input channel
SELF PRE EQ
The signal immediately before the
EQ (attenuator) of the currently
selected input channel
SELF POST EQ
The signal immediately after the EQ
of the currently selected input chan-
nel
CH 1–32 {64} POST
EQ, STIN1L/1R–4L/4R
POST EQ The signal immediately after the EQ
of the corresponding input channel
(*1)
MIX OUT 13–16
The signal immediately after the ON
of the corresponding MIX channel
For an output channel
SELF PRE EQ
The signal immediately before the
EQ (attenuator) of the currently
selected output channel
SELF POST EQ
The signal immediately after the EQ
of the currently selected output chan-
nel
MIX 1–16 POST EQ,
MTRX1–8 POST EQ,
ST L/R, MONO, POST
EQ
The signal immediately after the EQ
of the corresponding output channel
(*1)
MIX OUT 13–16
The signal immediately after the ON
of the corresponding MIX channel
• If the dynamics type of DE-ESSER, the key-in signal is fixed
at SELF POST EQ and cannot be changed.
HINT
• If you move the cursor out of the KEY IN SOURCE box while
the key-in signal is blinking in the box, your change will be dis-
carded, and the key-in signal setting will revert to the previous
choice. To confirm your new choice of key-in signal, press the
[ENTER] key without moving the cursor.
NOTE
• You can also use a dedicated library to save or load dynamics
settings at any time ( → p. 120). You can also take advantage
of a wide variety of presets suitable for various instruments or
situations.
HINT