Yamaha LS9 User Manual
Page 84
84
Operations in the SELECTED CHANNEL section
LS9-16/32 Owner’s Manual
● Adjusting the send levels from a spe-
cific channel to the MIX buses / MATRIX
buses
Use the SEND field when you want to send the signal
from an INPUT/ST IN channel to a MIX bus, or from a
MIX, STEREO, or MONO channel to a MATRIX bus.
1
SEND popup button
This accesses a popup window where you can make send
level settings for eight channels at a time.
B
TO MIX LEVEL (TO MATRIX LEVEL) knobs
These knobs indicate the send level of the signal sent from
that input channel to each MIX bus or MATRIX bus. If the
send-destination MIX bus / MATRIX bus is set to stereo,
the left knob of the two adjacent knobs will operate as a
PAN knob. (For a ST IN channel, a stereo MIX channel, or
STEREO channel, it will operate as the BALANCE knob.)
C
TO MIX ON/OFF button
If the send-destination MIX bus is a FIXED type, the TO
MIX LEVEL knob will not appear; instead, the TO MIX
ON/OFF button will be shown. By moving the cursor to
the TO MIX ON/OFF button and pressing the [ENTER]
key, you can turn the signal sent from that channel to the
MIX button on/off.
To adjust the send level to a MIX bus / MATRIX bus, use
the keys of the MIX/MATRIX SELECT section to select
the send-destination bus, and use the SELECTED CHAN-
NEL section [SELECTED SEND] encoder. (Alternatively,
move the cursor to the TO MIX LEVEL/TO MATRIX
LEVEL knob in the screen, and operate the dial or the
[DEC]/[INC] keys.)
If desired, you can use the TO MIX ON/OFF buttons to
switch the signal sent to each bus on/off (if the MIX bus is
the FIXED type).
At the left side of these buttons is shown the position from
which the signal is sent from the current channel. (For
details on changing the send position
Subsequent operations will differ depending on the
parameters you want to adjust.
1
2
3
• If you want to make send level settings for eight channels at a
time, use the SEND popup button in the screen to access the
popup window (
• If you’ve turned on POPUP APPEARS WHEN PRESSING
KNOBS in the PREFERENCE popup window (
→ p. 194), you can
also access the above popup window by pressing the SELECTED
CHANNEL section [SELECTED SEND] encoder.
• You can access the SEND popup window by moving the cursor to
the To MIX SEND knob of a VARI type, and pressing the [ENTER]
key.
• For MIX buses that are set to STEREO, the left knob indicates the
PAN of the MIX SEND, and the right knob indicates the SEND
LEVEL.
HINT