Accessing system features during startup – Dell POWEREDGE 2950 User Manual

Page 12

Advertising
background image

12

About Your System

Updates are sometimes included with the system to describe changes to the system, software, and/or
documentation.

NOTE:

Always check for updates on

support.dell.com and read the updates first because they often

supersede information in other documents.

Release notes or readme files may be included to provide last-minute updates to the system or
documentation or advanced technical reference material intended for experienced users or
technicians.

Accessing System Features During Startup

Table 1-1 describes keystrokes that may be entered during startup to access system features. If your
operating system begins to load before you enter the keystroke, allow the system to finish booting, and
then restart your system and try again.

Table 1-1.

Keystrokes for Accessing System Features

Keystroke

Description

<F2>

Enters the System Setup program. See "Using the System Setup Program" on page 38.

<F10>

Opens the utility partition, allowing you to run the system diagnostics. See "Running the
System Diagnostics" on page 131

<Ctrl+E>

Enters the Baseboard Management Controller (BMC) Management Utility, which allows
access to the system event log (SEL). See the BMC User’s Guide for more information on
setup and use of BMC.

<Ctrl+C>

Enters the SAS Configuration Utility. See your SAS adapter User’s Guide for more
information.

<Ctrl+R>

Enters the RAID configuration utility, which allows you to configure an optional RAID card.
For more information, see the documentation for your RAID card.

<Ctrl+S>

Option is displayed only if you have PXE support enabled through the System Setup Program
(see "Integrated Devices Screen" on page 42). This keystroke allows you to configure NIC
settings for PXE boot. For more information, see the documentation for your integrated NIC.

<Ctrl+D>

If you have the optional Dell Remote Access Controller (DRAC), this keystroke allows access
to selected DRAC configuration settings. See the DRAC User’s Guide for more information
on setup and use of DRAC.

Book.book Page 12 Friday, February 3, 2006 11:09 AM

Advertising