Removing the cooling shroud, Installing the cooling shroud – Dell POWEREDGE 2950 User Manual
Page 67
Installing System Components
67
Removing the Cooling Shroud
1 The cooling shroud is secured with a latch at the end of the shroud. Release the latch by pulling it
towards the outside wall of the chassis. See Figure 3-10.
2 Rotate the shroud upward and toward the front of the system on its hinges, and then lift the shroud
out of the system.
Figure 3-10.
Removing and Installing the Cooling Shroud
Installing the Cooling Shroud
1 Align the hinges on the shroud pivots located on either end of the fan bracket. See Figure 3-10.
2 Slowly lower the shroud straight down into the system until the fan connector engages and the latches
snap into place.
1
shroud pivots (2)
2
cooling shroud
3
release latch
4
shroud hinges (2)
5
fan bracket
1
3
4
2
5
Book.book Page 67 Friday, February 3, 2006 11:09 AM